The crank position sensor is located by the crank shaft on a ford 350 xl 5.8 liter.
The throttle positioning sensor is located in the throttle body.
yes the 7.3 DI power stroke has a Crank sensor and a Cam sensor.
Chevy did not use a crank sensor on that year.
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
It does not have 1.
The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
It is in the disturber itself.
You can find the crank sensor on the back of your 1993 3.4 liter engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
THE CRANK SESOR IS LOCATED BEHIND THE STARTER ON THE 2.2.
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
99.9% sure its your crankshaft positioning sensor.
Doesn't have one, it has a distriburator
the cam positioning sensor is on the passenger side of the engine block near the bottem. the best way to access is through the wheel well.
Bank 2 is the drivers side of your Mustang 4.6 liter Sensor 1 is between the engine and the catalytic converter ( upstream ) Sensor 2 is in the exhaust after the catalytic converter ( downstream )
You can test a 1994 Chevrolet Cavalier 2.2 liter engine crank sensor with a diagnostic tester. Most Chevrolet dealerships have diagnostic testers.
crank sensor is located at the top of the transmission bell housing,two hex bolts that hold the crank sensor in place.
behind the harmonic balancer pulley, i believe.
I believe it is mounted on the firewall , just to the right of center
the throttle positioning sensor is located under the gas petal on the side of the bracket that the petal bar is attached to
on back of engine behind the flex plate.
The crank sensor will be located iether behind the harmonic balancer or right on the side of the engine block