The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
its locted by the crank pulley the ower pully on the car
If you have a 2.2 engine ( 4 cyl. ) it is located under the ignition module at the back of the engine . Follow the plug wires to the coils, under the coils is the module under that is the crank sensor.
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
It will be on the back side of the engine where the distributor used to be on older engines.
Remove starter and sensor will be just above it.
where is the crankshaft sensor location on a lincoln ls v6 2003
You must know the engine, such as 4.2liter
12 valve engine: front above the crank pulley 24 valve engine: behind the starter.
behind the engine,in front of the transmission, about half way up the side of the block, its very hard to see its near the knock sensor.
On 3.1L Engines it is on the front of the engine above the starter mounted in the engine block. On 2.2L engines it is above the oil filter mounted in the engine block.
The crankshaft position sensor is located on the front of the engine inside the timing belt cover
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine