I have repaired many geo metro 1.0,, 5 speeds and have changed out the flywheel.
This does not require to be installed the same as it came off.
The flywheels have been balanced when machined and doesn't require to be installed any certain way..
take the tranny out and the flywheel is right on back of the engine, unbolt the flywheel and take it off and install new flywheel with new bolts and torque them down.
damaged the magnetic trigger on the flywheel or damaged/did not install correctly position sensor in trans bellhousing.
Flywheel clutch face surface facing out and line the bolt holes up. That's the only way it can go.
Separate the tranny and engine...It's in there.
starter gear is to close to flywheel install starter shim
To install the clutch on a 1987 Honda Civic the transmission will need to be taken off. Remove all the components to drop the transmission. Once removed loosen the bolts that hold the flywheel and clutch disks. Replace the parts.
yes you can and you must have on right or starter will bind up
The crank position sensor (ckp) is located at the back of the motor,driver's side, mounted to the transaxle housing. It gets it's single from the flywheel teeth. First unplug it and then remove the retaining bolt and pull it up and out. Reverse precedure to install.
turn the flywheel with a big screwdriver
It is easier to do if you install the torque convertor to the transmission and then attempt to bolt it to the flywheel. You will have to turn the convertor or flywheel to line up the bolt holes.
remove the transmission and take the bolts out of the flywheel on back of the engine and install the new one and tighten the bolts back up, you will have to find out what the bolts are torqued at as I'm not sure.
How do you install crankshaft position sensor 95 BENZ C220?