The ignition switch is riveted in place on many older motorcycles. If you don't own a riveting tool then you can fasten it with two small bolts and nuts. The wiring is easily reconnected as the proper connectors come with the new switch. If not, you have to figure out how to connect the wires to the switch by soldering them in place. You need the service manual for this. In general, the colors of the wires are the following: The black wire is the 12 volt power wire, the brown is the running lights, the yellow is the left turn signal and stop light, the green wire is the right turn signal and stop light, the white is the ground wire attached to the bike's frame. Blue is for the brake light.
www.denniskirk.com
sure it can
how do you install new ignition switch on 1989 chevy G10 van?
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.
How to remove ignition switch on a 91 Mazda Navajo
Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out and you can remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
Depending on the type and model of motorcycle, the ignition switch can be easy to change. Many bikes have a ring that rotates like a nut to remove the switch, then the wiring plugs on.
You can change your 1995 Chevrolet ignition switch by removing the ring at the top of the ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
Remove the retaining nut from the ignition switch. Pull the switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
my granddaughter has a 1997 GEO prism LSI. i need to know how to remove the ignition switch
The 1992 Plymouth Cold ignition switch is held in place by a retaining ring. Remove the retaining ring at the top of the ignition switch. Pull the ignition switch out. Remove the wiring harness from the ignition switch. Reverse the process to install the new ignition switch.