I did this with a hammer.. it was fused on.
It took 3 grown men 1 1/2 hours to smash the thing until the rotor came off in pieces..
This also resulted in the bearing coming off (unexpectedly) which I had to repack in grease myself.. after that I had to take it to a service station because I must have got some dirt in it and the bearing went bad 6 months later..
good luck//
I would splash water around the studs it will run down and around the studs then hit it with a hammer between the studs hard it will pop off. remember water won't compress you may have to do this 2 or 3 times.
------------------
[Fr0stByte]
if hitting it will not help. sometimes its to stuck to the rotor that u can keep on hitting it till the bearings are damaged there is a quick solution that will solve it.
take u angle grinder. a small one will do. mines was 12 euros at a d.i.y.
cut next to the midsection of the disc [midsection is the part with the rotor inside and the bolts sticking out] from top to bottom.
even if u cut it half trough it will snap off when hit with a hammer.
now you have the disk with a flat side on one side. that will enable you to get your grinder up close.
now cut the the side of the disc in the now open side. and a not to deep cut from side to the center of the rotor. not touching the rotor of course
once done turn it and bang the top part hard and then turn to bang bottom part once.
this will most likely slit it towards the middle [remember this is made of cast-iron]
now u can gently tap the disk off.
if done carefully you will not have touched the rotor and you will not have banged the bearings to kingdom come..
good luck
I agree to all of the above - except I didn't try the water trick.Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub
2005 Toyota tacoma how to remove the brake rotor
Remove the tire and wheel from your 1995 Chevy. Remove the brake assembly. Tap on the brake rotor with a mallet or hammer. The brake rotor will slide off.
Remove the brake caliper and hang it out of the way, then thread 2 8 mm bolts into the holes provided on the disk. Screw them in and the brake rotor will come off.
You remove the brake caliper frame and rotor is then loose.
Remove the wheel and tire assembly and the brake caliper then the brake rotor will slide right off.
Remove the tire and wheel from your 1995 Chevrolet K 3500. Remove the front brake assembly. Tap on the brake rotor with a hammer or mallet until it becomes loose. Slide the brake rotor off.
Remove the tire and wheel. Remove the brake pad springs and hardware. Remove the brake rotor. Reverse the process to install the new brake and rotor.
How do you remove the rear brake rotor on a 2005 Dodge Ram 2500?
Remove the wheel, remove the brake caliper and the caliper adapter bracket, pull the rotor off of the wheel studs.
You didn't specify brake rotor or ignition rotor. If it's the brake rotor, remove the front wheel, remove the brake caliper, remove the bearing dust cap, remove the cotter pin, and then remove the castle nut, this will free up the rotor to be removed from the spindle. While it's off you may as well replace the wheel bearings. If its the ignotion rotor you simply remove the distributor cap, and then two screws hold the rotor on.
your goin to need a BFH and a torch end of story. lol yea right ull prolly be there a while beating and heating