More advice from Wiki s Contributors:
There are products on the market that were originally created to specifically meet this type of need.Today they are used for a wide variety of cleaning and removing purposes however they still do a great job for removing dried dripped or spilled latex paint from finished,painted or glazed surfaces.The two most well-known brands are "Oops" and "Goof-Off".These products are sold at most hardware or home improvement stores and are also sometimes found in the cleaning aisles of grocery stores and department stores.
If your spills are on vinyl flooring,carpet or other similar surfaces be sure to read the label carefully as these products can sometimes damage those types of materials.If you feel you have questions shop for these products at businesses that offer knowledgeable saleshelp to assist you.
I'm using Mr. Muscle cleaning fluid and using a steel wool cleaner to rub the paint off. It does get the paint off the grout, but you need to be careful not to scratch the tiles. We're painting the tiles afterwards so not too worried about damage.
There is a product from Australia that is a broom on mop off grout cleaner no nasties www.pinkstuff.com.au. It gets paint off tiles I am a messy painter and I just made a solution let it sit and then mopped the paint splotches off and ended up with immaculate tiles and grout.
Make a strong solution out of dishwasher tablets or powder and keep dabbing it on and working at it with a scrubbing brush. Rinse off.
Beware dishwasher powder is the strongest cleaning agent in your home so wear gloves and protect eyes.
Also works on felt tip pen on bare wood but causes bleaching - even if you rinse well, if possible do whole area.
Tough one, as grout is like a micro hard sponge.
Latex is water based, so if you use hot soapy water and apply it to grout area
and let it sit for 3-5 minutes, then use a tooth brush / hard bristles and scrub it with that kind of brush in all directions, it should help.
Rinse and Repeat until satisfied.
Hope this helps.
Æ =)
Unless your grout was well sealed, that may be impossible. Unsealed grout will soak up paint to the extent it may be necessary to either remove the grout or paint over it with special grout paint.
To remove emulsion paint from plaster use a steamer. Another option would be to use a scraper or a block.
soak with water until it softens and thegently scrape
Color of what grout lines? I wouldn't grout colorant (only aquamix) works good for that if grout is not sealed.A far as ceramic tiles go Ive never seen a kind where acid will do anything good.
Non Sanded grout can be used in any size grout joint but is ideal in smaller joints usually up to 1/4" The main draw back to using unsanded grout in larger joints is that it may crack over time. If you are unwilling to remove all the grout and use a sanded grout, it is best to make sure the grout is cured and sealed properly to limit and minimize cracking.
A cheap way of cleaning ceramic tile grout is to use bleach and baking soda mixed with water and a toothbrush to scrum between tiles. One can also use a steam cleaner.
You don't need to seal ceramic tiles if you use epoxy grout you will be fine with the high traffic
It all depends on the sealer you used! I use a product called StableCrete that penetrates into the grout joints to waterproof them without leaving a film. Ready for light traffic in four hours. The Grout is what you seal with a ceramic install and not the ceramic!
No it shouldn't, but you should still grout your tile.
Epoxy grout is great stuff & it is stain resistant!
You remove oil based paint on tile floors by using a strong detergent mixed with water and a soft cloth
To remove ceramic tiles without damaging them, you can follow these steps: Start by removing the grout surrounding the tile using a grout saw or utility knife. Use a putty knife or chisel to gently pry the tile away from the surface, starting from the edges. Apply even pressure to avoid cracking or breaking the tile. If the tile doesn't come off easily, use a heat gun to soften the adhesive underneath. Be careful not to overheat the tile. Once the tile is loosened, continue prying it off gradually until it is completely removed.
yes
soak with water until it softens and thegently scrape
Remove the old ceramic tile starting at one of the edges. The best place to begin is where the old ceramic tile butts up against a different type of flooring, such as a carpet or wood floor. Chip away at the grout surrounding the old ceramic tile, using a metal putty knife and hammer. Set the putty knife on the grout and hit the top of the putty knife with the hammer. Work your way around the first tile pegged for removal.2 Slip the blade of the putty knife under the ceramic tile after loosening the grout. Apply pressure to the handle of the putty knife and pop out the old ceramic tile.3 Chip the grout away from the tiles and pop the tiles out, using the putty knife, until you have removed all of the old tiles.4 Vacuum the area with a wet/dry vacuum to remove any residue.
Color of what grout lines? I wouldn't grout colorant (only aquamix) works good for that if grout is not sealed.A far as ceramic tiles go Ive never seen a kind where acid will do anything good.
Ceramic tile grout cleaner is most certainly not safe to use around children as it will contain various harmful chemicals. It is better to look for a specific non-toxic grout cleaner instead.
If it is chunks you are referring to, a scraper or screwdriver will pop them up. If it is the haze or film after a fresh installation, hit it again with a sponge and clean water.
You can buy a little scraper tool that has a pointed or 'v'shaped end to clean the gap between the tiles without damaging them. after that its a matter of re-grouting. Make sure the area is dry first - rubbing alcohol works well.