I had a hard time before i figured out how to remove my old ignition cylinder to put in a new one... I did this because my old one ond day just stopped working... It just wouldn't turn... so I boutght a new cylinder (it comes with new keys) from auto zone... cost about $26.99.... n e way hope this post helps n e 1...
Honda ACCORD 92 DX
First remove the 5 screws that hold the stering column with a star point screw driver (you might need a ling screwdriver)...
Remove the casing to expose the ignition assembly
Use a flat head screwdriver to remove the outer shell of the ignition cylinder (black round thing around the turnig part)
Remove the locking screw (I just used a bird beak pliers to back it out because of the odd location " it right by the middle arrow")
Put in the key and turn it to position I.. (Turn on the ignition... don't start it...)
Use a firm tool to depress the locking pin located behind the lock screw towards the stering whele shaft...
Thought U don't see my key in the ignition U MUST HAVE THE IGNITION ON!!!
while depressing the pin hold the key firmly and pull the cylinder out (rock it a but it should come right out)
I couldn't get the new one in cause the new pin on the new cylinder wouldn't depress... (when installing the new one leave the key in the on position)...
I just used a set of pliers to pluck it out... then just used the locking screw to hold it on.... dosent really matter tho...
no the switch can be independly remove from the back side of the ignition lock
how to change manual ignition switch on a 93 Honda accord
Ignition switch
Turn the ignition switch clockwise until it starts, then release.
How do replace the ignition switch on 1995 Honda Civic EX with a manual tranny. I was wondering if it is pretty much the same as the 1995 Accord.
how to put in a ignition on a Honda accord 1991
Could be a bad ignition switch
Examine the ignition setup. There should be a panel with five to eight wires clipped to the rear of the tumbler. Remove the panel and try to manually turn the ignition switch using a screwdriver. If you can do this, then you are done!
how to change dimmer switch on 1997 Honda accord
The Honda Civic 1.6 liter engine ignition switch is held in with a retaining ring. Unscrew the retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
check to see if your car has had the ignition switch recall completed
In order to replace the ignition switch in a 1997 Honda CR-V, you must first unplug the ignition switch power source. Unscrew the cover panel, remove the bolts holding the switch, and pull the switch out of the column. Replace the old ignition switch with the new ignition switch, return the bolts and screws, and reconnect the power source.