You'll need to remove the heads and have a machine shop replace the valves, and possibly valve seats. Replacing valves is NOT a job for your average do it yourselfer. Even if the seats are fine, you need special tools to cut them for the new valves. You will also need to use lapping compound to seat the new valves to the new, or re-cut seats. If you want it done right, just pull them off and take them to the machine shop.
buy a new valve
Leaking valve cover gaskets?
Engine miss, poor fuel economy, loss of power, and low compression on the cylinder with the burnt valve.
You can have a compression test done on the engine to determine the condition of the rings and valves.
egr valve used to reduce emmisions. the valve will open at driving speeds to reburn exaust gases. when one fails it will usually be in the open position thus the engine will run rough at Idell.
judge the color and smell of exaust!
Most likely cause is a burnt out inlet valve. You need to do a compression check.
The engine will have low compression and misfire, especially at idle. The misfire will seem to disappear at higher RPM.
First, lets talk a little bit a bout what does an EGR system do. The EGR valve either electric or mechanic is a component part of the emission system. It was designed to let back into the running engine a very small portion of burnt gases in order to decrese the posibilities of Nitrus Oxide formation (NOX). The PCM sends a signal to the EGR valve to open it over 1500RPM so the engine wont feel the burnt gas and fail. If the gas enters the engine below 1500RPM, the engine will fail and hesitate because a small portion or burnt gases will enter the intake manifold and contaminate the air/fuel mixture and a very nasty smell will come out of the exaust pipe do to impropper combustion. Also, the manifold absolute preasure will be nearly the same as that of the ambient and would probbaly make the engine to stall. If the EGR is stuck closed, no symptoms would be felt as from the engine funtionability perspective but if we talk about an electric EGR valve, the CHECK light will turn on and the PCM will create a DTC. Hope this helps. Good luck
Burnt valves will cause power loss. Another symptom will be the engine will run hotter than normal and use more antifreeze.
replace egr valve.
On the 4.0 L OHV engine, the EGR valve is located on the driver's side of the engine. how do i repair it