Hello I have a 1992 Hyundai EXCEL..just changed mine..but its a standard shift..first disconnect the NEGATIVE battery cable..stops any airbag accidents..take pliers..DISCONNECT end at TRANI..run new speedo cable the same way the old one goes..pull out RUBBLER BLACK grommet behind DISTRIBUTOR CAP..this grommet stops water getting inside dash .Its under the hood inside firewall (behind distributor cap). NEXt undoes the 3-4 screws inside car that hold your plastic intrument gauges....pull out SLOW..behind it is WHITE plastic piece..SQEEZE together..this piece will release the old speedo cable..PULL this white plastic piece AWAY FROM YOU..it releases the old cable..its a difficult job..worse than u think, but it can be done..took me over an hour...the worse thing was trying to remove the WHITE plastic housing behind DASH guages..I was pulling it the wrong way..must be BACKED OFF away from you..GOOD LUCK
Speedometer cable replace 1989 toyota
The speedometer is electronic on a 1999 Ram, and does not have a cable.
There is no speedometer cable on that vehicle. The speedometer is driven electronically.
A 2004 Buick does not have a speedometer cable. The speedometer signal comes from electronic sensors.
There is not an odometer cable. The odometer is driven by the speedometer. If the odometer is not working then you will have to replace the speedometer head.
You can fix the speedometer in your 1994 Oldsmobile 98 by replacing the speedometer cable. If changing the speedometer cable does not fix your speedometer you will need to replace the entire speedometer.
You need to disconnect the cable from the transaxel. Then you pull out your dash cluster. Remove clip from speedometer cable then just pull it out. Reverse for installation.
I pretty sure it doesn't have a speedometer cable, it is electronic.
its electronic, there is no cable
Goto www.hmaservice.com (Hyundai webtech 2000) Set the Model Year and engine drop-downs on the top of the page and then click Search on the far right. Enter the search keword "speedometer" (leave all items as the default values) You'll see a "Speedometer Replacement Cable" document that you can click on. This contains all the details you need. Enjoy!
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
The speed sensor is a timy magnetic reed switch located inside the speedometer cluster in the dash. The reed switch is magnetically triggered by a magnet that spins in the speedometer cable.