0
Replacing a thermocouple basically consists of removing the connection nut on the old thermocouple in order to remove it. Then insert the new thermocouple in its place and tighten its connection nut to hold it in place.
See the related link for a more detailed explanation as well as some helpful diagrams.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you replace a thermocouple on a gas fireplace?
Is there any video on how to replace a thermocouple on a gas fireplace
How do you replace a thermocouple on a boiler?
nice
How do you clean thermocouple on hot water tank?
You do NOT clean a thermocouple. They are really inexpensive and when they are giving problems have a LMP / or Gas fitter replace it
How do you replace a thermocouple on a hot water heater with pictures?
There are many pictures of this on Google.
How do you replace thermocouple in a Williams wall unit?
unscrew it replace it, copper pipe coil easy to replace. Two pipe nuts about 3/8"
How do you replace a thermalcoupler on water heater?
Older ones where you light the pilot through the access panel, the thermocouple pulls out of a clip at the pilot light and unscrews from the bottom of the control valve. Pull and twist it at the pilot to get it out of the clip. Newer ones with a spark igniter and sealed at the bottom, you are going to have to take the panel and the burner assembly out as a unit so that you can replace the thermocouple. Unscrew the pilot light gas supply tube and the thermocouple from the control valve, remove the screws holding the view plate on and the whole thing slides straight out the hole. Replace the thermocouple and re-assemble.
Why wont your electronic ignition water heater stay lit for more than a few seconds?
Electronic ignition refering to it having a sparker to light the pilot light? That just lights the pilot, there is still a thermocouple that controls the gas valve. The thermocouple is the small tube that sits in the pilot flame and runs to the control valve. To replace, you will need to remove the cover plate, gas line, thermocouple, and sparker wire as a unit and replace the thermocouple once you have it out and them re-install the unit.
How do you replace thermocouple on Sears hot water heater?
Depends on the age of the heater. If you light the pilot with a match, you should be able to remove the thermocouple with the burner in place. The end that is in the flame will pull out of the clip that holds it. The control valve end unscrews. If you have a newer one that lights the pilot with a sparker, you have to remove the burner as a unit. There should be two screws holding the cover plate in place, the gas line to the burner, the thermocouple and the wire for the sparker. Disconnect all of these from the control valve and the unit slides out through the hole. Then change the thermocouple and replace.
How do you repair a gas fireplace?
Replace the thermocouple. The skinny copper line that goes from the gas valve to the pilot and senses when it is lit.
Is thermocouple output linear?
The output of the thermocouple is linear.
What does it mean when the water heater wont say lit?
Most likely the thermocouple is bad. The thermocouple is the little tube that sits in the flame of the pilot light. Runs from the pilot light to the control valve. Very simple to replace. Costs about $6.
How much to replace thermocouple on water heater?
Usually less than 1 hour work, ( but nobody will bill one hour) Part costs less than $10 and any competent handyman can do it.
