0
Assuming you are going to replace the 99/04 Jeep Grand Cherokee blend doors yourself.
You would start by disconnecting the negative battery cable.
If you are going to remove the dashboard, etc to replace the blend doors.
some websites give you complete instructions with plenty of pictures.
It will take the average person with little or no auto repair skills approximately 12 to 16 hrs.
The vehicle will have to be taken to a shop that can recover the refrigerant before you start removing the dashboard and HVAC box..
If you are going to do the type of repair where you cut an access hole in the side of the HVAC box.
A short version of how the access hole repair is done.
Disconnect the Negative battery cable.
Lower the glove box - by hand
Remove the actuator motor - You will need a Phillips screw driver
Cut an access hole in the plastic HVAC box - I supply a multi-purpose cutting bit, you will need a rotary type of cutting tool, like a Dremel, RotoZip, etc. Or you could do the cutting by hand with any type of small cutting tool, it will just take longer doing it by hand. Or some customers used a narrow pointed soldering iron!
Remove the broken blend doors - by hand
Install the new Blen Dor Store dual control kit
Replace the actuator motor.
Close the access hole - Replace the wall piece of plastic you cutout - I supply an aluminum tape to cover the groove made by cutting the wall.
Close the glove box - Your Done!
It is almost as easy as what you just read, the hardest and the most time consuming thing to do is cut the access hole.
The job should take between 30 minutes to 1 ½ hours. Depending on how long it takes you to gather your tools, etc.
---------------------------------------------------------------------------------------------------------
Video's of the repair and expert support are available online. Check for a full explanation of the problem and repair process.
Again disconnect the negative battery cable first.
This type of repair takes an average of one hour to complete.
The work is done behind the glove box.
You would cut a 5" x 3" access hole.
Remove the broken plastic blend doors, etc
Install the new aluminum blend doors, drive connector with stop limited pin.
Replace the cutout section and apply an aluminum foil tape on the cut line.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you replace blend door actuator on 97 ford expedition?
How do i replace blend door motor
How do you replace blend door actuator motor on 1999 ranger?
how to replace a blend door actuator on a 1999 ford ranger
How do you replace a blend air door on a 2000 Pontiac Bonneville?
how do you replace a blend air door assembly on a 2000 pontiac bonneville
How do ypu replace a blend door on a 1999 voyager?
To replace a blend door on a 1999 Voyager, you will begin by checking which side of the vehicle is not receiving heat. Then, remove the glove box door by squeezing the inside of the door toward the center of the door to access the blend door.
Where are door blends on jeep Cherokee limited 2002?
do you have any pictures were the blend door actuator is located on a jeep grand cherrokee limited 2002
How do you replace the blend door on a 2002 mercury mountaineer?
If you do a Google search on Ford Explorer blend door there are lots of articles
How do you replace an electric blend door in a Chevy blazer?
Remove the dash assembly to gain access to the blend door actuator.
How do you replace blend door actuator on 1997 Pontiac Bonneville?
locate blend door actuator for 1997 pontiac bonneville se
How do you remove a dashbard from a 91 Jeep Grand Cherokee to replace blend door?
First, it's not necessary to remove the dashboard to replaced the blend door with hardware from the guys on this web page. heatertreater.net If you want to remove the dash check the same web site Tech section for a video on pulling back the dash panel to replace the re-circ door. The complete removal process is outlined on www.wjjeeps.com
How do you repair a 2001 Jeep with climate control that is blowing all cold air when you have heater on or all heat when you have air conditioner on?
blend door is broken re-move dash and replace
How do you replace air door actuator in gm sonoma 1998?
Where is the blend door actuator on a 1998 Sonoma
Does the blend door prevent the air from being cold in a jeep grand Cherokee 2001 or does it just stop the heated air from getting through?
The blend door controls how warm or cold the outlet air is.
