you have to do this from under the van. jack the vechicle up and be sure to support it on jack stands for `safety. right behind the pulley ia a 15 mm bolt this bolt is the only bolty that holds the pully on. it is harde to get to a person with small hand has little or less problems.
No I don't think so.
this link ^ should help you out
bad tensioner, replace the belt tensioner/pulley. I had the same problem.
Most likely the new pulley is not in line with the rest.
I had this problem in my 92 Plymouth Voyager. You need to replace the tension pulley. They get old and become out of alignment.
There is no adjustment. If it does not provide the correct tension it needs to be replaced. It is cheap and easy to do yourself from underneath.
Replace the tensioner assembly as one piece.
You will have to replace the regulator assembly.
Call the parts store. They will be able to tell you if the pulley is available separately or not.
Well!? I am just going through the hell with this problem. Pulley is made out of plastic compound - bakelit. You will have to remove a drive shaft in order to take a pump with the pulley out. You need a special pulley remover to do the job for you - on your work bench. Another option is braking the old pulley and chipping the pieces out. Mounting a new pulley is a another issue. You will need a compressor and a pneumatic gun to mount a new pulley on the shaft of the PS pump.
push the tensioner back with a 14mm, take off the belt, take off the pulley assembly
Loosen the bolt in the center of the idler pulley. Then loosen the pulley and remove the belt. There is 3 bolts behind the idler pulley that remove the entire pulley assembly. One is located above the pulley to the top right and the other 2 bolts are below the pulley on either side. It will help to take the wheel off and remove the plastic access panel behind the wheel to the front side of the axle. Then you can drop the pulley out from the bottom and replace the pulley or whole assembly either one at this point. Reverse instructions to reassemble.