How do you reset your check engine light after an oil change in a Pontiac Aztek?

What is the oil capacity for a Pontiac Aztec?

2002 PONTIAC AZTEK 3.4L 6-cyl Engine CAPACITIESEngine, with filter..........4.6 quarts[1]1. After refill check oil level. Since the Year was not provided here is a General Idea Double Check it at the "Capacity Lookup" I provided you. Happy Oil Change.

How do you change the heater core on a Pontiac aztek?

To change the heater core on a Pontiac Aztek, locate the heater core on the firewall, passenger side of the vehicle. Remove bolts on the firewall and the clamps on the hoses. Take out the old heater core and replace with new. Tighten bolts and hose clamps. Then check to make sure the radiator is full of antifreeze.

How do you reset the check engine light after an oil change on a 2004 Pontiac Vibe?

The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.

Pontiac G6 has check engine light with a wrench?

pontiac g6 check engine light car with wrench

When AC is on car smokes under the hood does not smoke when the AC is off 2001 Pontiac Aztek?

Check the driver belt, tensioner and the a/c clutch and compressor.......

How do you reset check engine light after oil change on a 2001 ford expedition?

How to Reset the Change Engine Oil Message The Aztek uses the GM Oil Life System to calculate when to change your engine oil and filter based on vehicle use. It is widely thought to determine oil life by counting engine revolutions. While there is much debate about the merits of such a system as a basis for determining when to change engine oil, the system should be reset after each oil change to ensure that the CHANGE ENGINE OIL message does not appear inappropriately. There are two procedures for resetting the system, one for Aztek's with a DIC (Driver Information Center) and one for Aztek's without a DIC. PROCEDURE 1: Aztek's with a DIC 1. Turn the ignition to ON with the engine off. 2. Press the MODE button until the DIC reads "OIL LIFE LEFT/HOLD SET TO RESET" 3. Press and hold the SET button until 100% is displayed. You will hear three chimes and the CHANGE ENGINE OIL message (if illuminated) will go off. Repeat this procedure if the CHANGE ENGINE OIL message comes back on. PROCEDURE 2: Aztek's without a DIC 1. Turn the ignition to ON with the engine off. 2. Fully push and release the accelerator pedal slowly three times within five seconds. 3. Turn the key to OFF. If the CHANGE ENGINE OIL message continues to be illuminated, repeat the procedure.

Possible causes for a 2001 Pontiac aztek to quit running while driving?

It could be the electrical ignition system. there is a recall, dealers will replace the ignition relay free of charge. check it out. Pontiac tele. #1-800-620-7668

Why does the check engine light flash on a 2003 Pontiac Sunfire?

If a check engine light is flashing that means an engine cylinder misfire has been detected

Why check engine light came on after changing brakes on Pontiac vibe?

Check the brake fluid...

Why is your 1993 Pontiac Trans Am taking to long to change gears?

Transmission fluid is low. Check the level of this fluid ONLY with the engine running and at normal operating temperature. To check it otherwise WILL give a false reading. You cannot check the transmission fluid level on a cold and idle engine.

How do you reset the service engine soon light on a 01' after an oil change?

Just disconnect the battery for about 2 mins and then reconnect. Open the glove box, reach in and remove this little book called an Owner's Manual. Inside this little book is all kinds of answers to this and many other questions. You will find it invaluable for future reference. Answer; How to Reset the Change Engine Oil Message The Aztek uses the GM Oil Life System to calculate when to change your engine oil and filter based on vehicle use. It is widely thought to determine oil life by counting engine revolutions. While there is much debate about the merits of such a system as a basis for determining when to change engine oil, the system should be reset after each oil change to ensure that the CHANGE ENGINE OIL message does not appear inappropriately. There are two procedures for resetting the system, one for Aztek's with a DIC (Driver Information Center) and one for Aztek's without a DIC. PROCEDURE 1: Aztek's with a DIC 1. Turn the ignition to ON with the engine off. 2. Press the MODE button until the DIC reads "OIL LIFE LEFT/HOLD SET TO RESET" 3. Press and hold the SET button until 100% is displayed. You will hear three chimes and the CHANGE ENGINE OIL message (if illuminated) will go off. Repeat this procedure if the CHANGE ENGINE OIL message comes back on. PROCEDURE 2: Aztek's without a DIC 1. Turn the ignition to ON with the engine off. 2. Fully push and release the accelerator pedal slowly three times within five seconds. 3. Turn the key to OFF. If the CHANGE ENGINE OIL message continues to be illuminated, repeat the procedure. ---------------------------------------------------------------------------- Check your owners manual. If you don't have one check Related links below.

How many quarts of engine oil does a 1968 Pontiac Le Mans take?

5 quarts, run it and check level.Most Pontiacs take 6 with a filter change.