With the car turned off, hold down the RCL button.
While holding down the RCL button use either the AUTO/TONE or TUNE/SEEK button to change the time depending on the model of your radio. The left side will change the hours... the right will change the minutes.
On the clock there are two small indented buttons next to the display one is for hours the other for minutes. You will need a pen or the tip of a key to push the buttons
if like mine ....push and hold the clock button until the hour flashes , then turn the volume knob to desired hour, hit the set button again , the minutes should flash , turn volume knob to desired minutes , hit clock button again
go to eBay n look for an owners manual, or go to a nearby salvage yard n look through all the wrecked trucks to find an owners manual. that's what i did to get the fuse panel for my boyfriends truck.
If its the factory unit, look at the face of the unit and there should be 2 tiny little buttons (holes) on the front. One has an H (hours) next to it and one has an M (minutes). Use a paper clip or a pen and adjust the time.
I had clock reset to correct time in 15 seconds, they knew their stuff .! Thank You Answers.. "DoZer"...
Well, if it is like my 2002 Ford Windstar, you press and hold the clock button and use the seek and tune buttons to change the hours and minutes.
unpluged te batery at 12:00 and conect it again. the clock will start a the rigt time. good luck!!!! ^_^ .
turn on ignition press right hand button on speedo for more than 3sec hours will flash press to change release button for 5 secs minutes will flash change minutes
An atomic clock should set itself once it receives the calibration signal .
Not sure what you're needing to do. But to set up the clock and the outdoor temperature sensor, make sure the batteries are new for both. Put the batteries in the outdoor sensor first. Wait to see the temperature reading on the sensor. Then put the batteries in the clock. In about 15 minutes the outdoor temperature should show on the clock. Do not set the clock until the outdoor temperature is displayed. You can set the clock manually, or set the button on the back to atomic so that it will automatically receive the time.
the time was 10:10
False
press and hold clock button for 3 seconds press the seek/track button up or down to set hours press the tune/ff-rew button up or down to set minutes press clock to exit
There should be no difference The difference between the two are the different set of heads and intake used on the 1999 that was not used on the 1997.
How do you set the timing on a 2300 mustang
If your radio has a "clock" button press and hold it while using the up/down tuner( or volume, i forget) button to set the time.
You can set the clock in your 2003 Ford Escape by holding in the volume button. With the volume button held in the clock display will flash. You can then set the clock by turning the tuning knob.
how do you set clock In 2011 f150
.050 inch spark plug gap - 1986 Ford Mustang 5.0 L ( 302 )
How do youchange the clock on a 2002 zx2 ford escort?
Press clock, type digits then ok
hold clock+seek for Hours hold clock+discs for minutes
how do you set or check the timing on a 99 ford expedition?
no. It's a live-rear axle set-up like the Ford Mustang. The is no Crown Victoria ever built for public consumption with an IRS.
hold clock button and use the seek or other button underneath while holding the clock button