You should be able to pull out the fuse panel (open your driver's door and look at the side of your dash). In it, you should see a reset button. Press it.
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
Turn ignition to ON position. Press brake pedal all the way down for about 3-5 seconds. Then pump gas pedal 3 times quickly. Start the car. Oil change light should go off. Works for 2002 Grand Am.
The airbag light stays on when the computer has detected a malfunction and set a code. The failure will need to be repaired before the light will shut off.
Try turning key to the "on" position without starting vehicle Depress accelerator to the floor six times Shut off key
Try turning key to the "on" position without starting vehicle Depress accelerator to the floor six times Shut off key
The reset button is located on the drivers side fuse panel. I believe that you turn the ignition on but don't start, push button til light blinks then push again and it will make a chime sound and light should go off.
The directions to reset the service reminder light are explained in your drivers manual.
Unless your seatbelt is on. aswell as other passengers, the seatbelt light will not turn off. It is a safety precaution and I highly doubt you can disarm it.
shut the engine off turn the key on pump the gas petal three time then turn the key off then start the pickup it should go off.
There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.
I had to change this a few years ago. If I remember correctly, the fan would not shut off.On line, I found the answers. Seems like it was on the driver's side around the wheel well (under the hood). Good luck. Chris
How can you shut off your anti theft alarm on a 2003 Ford Ranger