0
30 pound roof felt before your finish material.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you repair drywall hole and vapour barrier?
I tape the broken vapour barrier with red 'Tuck' tape then put a wood backing in the hole and use small pieces of drywall to patch.
Vapor barrier over studs and insulation and behind drywall or over drywall?
Vapour barrier is directly onto studs.
Can you safely use a vapor steam cleaner on your laminate floors?
Yes vapour steam cleaners do a fantastic job on laminate floors and many other flooring types. They will lift dirt easily and quickly with little effort. The floor will look nearly good as new after cleaning with a vapour steam cleaner.
When was the first cantilever bridge made?
The Niagara Cantilever Bridge or Michigan Central Railway Cantilever Bridge
Can you jnstall drywall over roofing papersd wood walls with out condensation?
I always have a poly vapour barrier. Better for the drywall.
What is the plural of cantilever?
The noun cantilever has a normal plural, cantilevers.
What is the point of a cantilever beam?
a cantilever beam is designed to evenly distribute weight
How are goods stored on Cantilever Racks?
Goods are stored horizontally on Cantilever Racks.
When was Niagara Cantilever Bridge created?
Niagara Cantilever Bridge was created in 1883.
How do you install lighting in ceilings with insulation?
Assume you are asking about recessed lighting. There are units that have a can around where the bulb is located to keep insulation a safe distance from the heat generated by the bulb. Just cut away the insulation so the can will fit. Buy a fixture that has thermal protection and will cut off if the fixture gets too hot. Follow manufacturer's recommended installation procedures. <<>> Don't leave your ceiling vapour barrier with a break in it. At the place where you buy your fixtures ask for a vapour barrier plastic boot to go over the fixture to seal the existing barrier. The easiest method to install this boot is from the top side in the attic if possible. Make sure that you use vapour barrier adhesive tape to seal the existing barrier to the new fixture boot.
How do you insulate an electrical outlet?
If the outlet is on an outside wall there is a plastic boot that goesaround the outlet. The purpose of this boot is to keep the vapour barrier intact. The edges of this boot are then taped to the wall vapour barrier to make a complete air seal. The insulation goes behind the outlet boot which allows the wall R value to remain the same as the rest of the wall.
What is the Hebrew word for cantilever?
cantilever = tmochah (תמוכה) or tomchah (תומכה)
