0
How long do I have to wait till the computer recognizes the change and the Check Engine light goes off after replacing a bad EGR Valve and EGR Solenoid Valve in my 98 Expedition?
Wiki User
∙ 16y ago
Try disconnecting the battery for about 10 minutes to reset the code Went to Autozone to see if I replaced the wrong part. They said I had to wait "a while" till the change was recognized. That the computer used some type of formula of engine starts, miles, and gears shifted through before it would turn it off. It has been 3 days, about 8-12 engine starts and about 30 miles.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Does a 98 expedition Oxygen sensor need codes when replaced?
Just reset your computer after replacing the O2 sensor.
What could be wrong with a 1988 Jeep Wrangler that wont fire even after replacing the ignition switch coil and solenoid?
try replacing the computer below the washer fluid. gave me a hassle for a few weeks when i replaced my coil.
How do you reset the computer on 1997 Ford Expedition?
how to reset the computer on a 1997 ford expedition
Are there Computer chips for 02 expedition 5.4?
Yes, there are computer chip for the 2002 Ford Expedition.
Will replacing RAM delete files stored on the computer?
No, replacing a hard drive will.
How do you calibrate an Xbox 360 wireless controller with a computer?
You have to go buy a special adapter for the computer that recognizes the controller.
What causes transmission not to shift into overdrive?
usually it is the overdrive solenoid, but can be the connector to it, input to the computer, or the computer.
Why computer needs binarry?
the computer does not understands the numers and alphabets , it only recognizes 0 & 1, which is known as binary digits.
Where is the computer module on a 2003 expedition?
Where would I find the factory key code location on a 2003 Expedition?
What are the two numbers that a computer can read?
A computer works in binary, meaning that a computer interprets everything as simply 'on' or 'off', and recognizes two numbers: zero and one.
How do you reset the computer on a 2000 Ford Expedition?
battery
How do you adjust the idle speed on a 1993 Plymouth acclaim?
It is not adjustable. It is computer controlled. If idle speed is incorrect you have a vacuum leak or a sensor/solenoid issue.It is not adjustable. It is computer controlled. If idle speed is incorrect you have a vacuum leak or a sensor/solenoid issue.
