It depends on the humidity, warmth, and other factors such as air movement and brand of sealer.
It'll be tough enough to walk on with sock feet in 24-48 hours. Most typical cure to maximum hardness are 3-5 days with constant air movement.
Only a pro can tell you for sure.
what is the purpose of reinforcing bars in a spread footing
no, not normally. It will cure more slowly and how much slower depends on how much dirt is piled on it.
all things that need to dry are based on 72 degrees concrete needs 30 days to fully cure.
Yes it can. It actually cures harder under water then above it. True.
Concrete never fully cures, but a non-quicksetting concrete should be firm on the surface in about 4-8 hours, and usable for foot traffic or post setting in 36 hours.
If you're dealing with a new slab, you must wait a minimum of 28 days, preferably two months, for the floor to cure and dry thoroughly before applying a garage floor coating.
Etching only benefits bare concrete floors. If you want to ensure that your new coating will adhere to your old coating, blend enough of the epoxy to cover a single square foot section, let it cure for a week, then check the adhesion by scoring a cross-hatch design in the new coating, put some duct tape across the scored area, then quickly pull up the tape. If the epoxy comes up, then you will have to remove the old coating prior to recoating the floor.
A thermoset is a material that cures or sets into a given shape, generally through the application of heat. A cured, thermoset material will not remelt or otherwise regain the processibility it had before being cured. Curing changes the material forever. A thermoplastic material softens (becomes pliable and plastic) when heated, but it does not cure or set. It can be reheated to be reformed.
28 days is the usual cure time for structural concrete. For street pavements and driveways made with 6-Sack concrete, 3 days of cure will support a car, but 7 to 10 days is required for it to support trucks. All concrete continues to cure forever, as long as moisture is present.
7 to 10 days.Method of testing:Duct tape plastic film to a 12"x12" place on the floor and if the plastic does not have any condensation and the concrete does not appear darker there after 24 hours, the concrete is dry enough. You can over spray it (seal it up), next day put flooring down.
what is the purpose of reinforcing bars in a spread footing
The first step of wood floor refinishing is sanding off the current finish. Make sure your flooring hasn't already been sanded too many times, or it may need to be replaced entirely. Start with a very coarse sandpaper and gradually move toward finer grits. Only apply one coat of the wood stain, or some parts of the flooring may absorb more stain and your finish will be uneven. The final step is applying the polyurethane coating. Coat several times and allow it to cure for 3 to 7 days before replacing furniture.
Yes and many so ask the supplier of your concrete.
Yes.
no, not normally. It will cure more slowly and how much slower depends on how much dirt is piled on it.
all things that need to dry are based on 72 degrees concrete needs 30 days to fully cure.
Yes it can. It actually cures harder under water then above it. True.