There is an easy fix kit called the "HeaterTreater" that is available on eBay and at heatertreater.net. This fix is all-inclusive, easy to install, and only takes about 45 minutes. It cover Ford Rangers and Explorers from 96'-04'
how to replace a blend door actuator on a 1999 ford ranger
How do i replace blend door motor
If you do a Google search on Ford Explorer blend door there are lots of articles
You buy a new car
You don't!
I do not have heat in the car and the blend door clicks. How do I access the blend door in a 2005 Ford Explorer?
To replace a broken blend door, typically a mechanic will disassemble the entire dash, and replace the plenum box. Unfortunately this is an expensive fix because it is labor and parts intensive. There is a DIY solution called heatertreater. They provide instructions on how to access the blend door by removing the glove box, and replacing the blend door without removing the dash and plenum assembly. Broken blend doors are a common problem among Ford explorers, and most heating and A/C issues in late model Ford explorers are directly caused by a malfunctioning blend door.Read more: 2004_ford_explorer_heater_problems_clikcing_noise
how do i replacement my blend door in my 1998 ford explorer
The blend door sits vertically in the heater box behind the glove box. If you fully open the glove box, you can see the actuator motor on top of the heater box in the upper left hand corner. On the bottom of the box is a "pedestal" that is the bottom axle point for the blend door. The door axis is between the motor axle and the pedestal. If you are having issues with a Ford Ranger blend door, you can find diagnostic procedures with pictures and a cheap easy solution to the problem at HeaterTreater www.heatertreater.net, or follow the Google ads on this site. cgallen
how do you replace a blend air door assembly on a 2000 pontiac bonneville
To replace a blend door on a 1999 Voyager, you will begin by checking which side of the vehicle is not receiving heat. Then, remove the glove box door by squeezing the inside of the door toward the center of the door to access the blend door.
Pull the door panel off, remove the door latch assembly from inside the door, and replace the switch which is hold onto the latch with one screw on the backside of the latch.