To drill into cement you require a masonary bit for your drill. Masonary bits can be bought at any local hardware store or such like. Drill into cement using masonary bit (protects your drill from damage) then push a wall plug into the hole. to secure position and any attachment you wish to add ie woodern beams. I learnt the hard way about following this proceedure being a female that had never changed a plug.
It's also helpful to have a hammer drill. They make a lot of noise, they drill into concrete much faster than a normal drill.
ANS 2 - You will save yourself a lot of time and hard work by renting a good hammer drill like a small Hilti or a medium sized Bosch. You can also find many ways of attaching screws into concrete at the Hilti store. 'HIT' screws in particular , save a lot of time. They combine the screw with a polypropylene shield. You hammer drill the hole and just pound one in -simple.
better try to avoid drilling on concrete beams......!!
easiest way is to core drill and use pour stone to cement it.
The colour is irrelevant , that just depends on the manufacturer. To cut through concrete you need a 'carbide tipped' drill bit. This tip is a little wider than the drill bit and is quite obvious.
Masonry refers to brick and cement. If you have to drill a hole in that kind of material, just put the masonry bit in your drill, and you can drill the hole in exactly the same way that you would drill a hole in wood, it works the same way.
typically referred to as a core-drill, it anchors to a surface and drills out large diameter holes......... actual drill bits for small holes (the type you'd use in your 3/8 drill or cordless) are carbide bits, and can also drill throgh ceramic tiles
No you cannot
Drilling through structural beams is strictly limited. You must have engineers approval.
you cannot get the tm but you can find the move drill peck with zapdos
Usually not. You may have to move the hole a bit or it may slip by it.
The seven-mile bridge that spans across the gulf of Mexico to connect two cities of the Florida keys
Drill bits and screws are not the same and cannot be converted. vido produces drill bits with high quality, exported overseas and loved by the public. If you want to buy a drill, you can go to VIDO's official website to check.
An AWL is a short pointed tool for making small holes. Mostly used in leather making. You cannot drill with it, it's smooth.