answersLogoWhite

0


Best Answer

No it is not safe because it may be possible that the load 15 A may take grater than 15 amp and your socket and wiring may burn or damage.so i will say that use 20 amp socket it will safe for your device and also for your wiring connection.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Is it safe to plug in a 15A dimmer pack into a standard 13A socket?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Movies & Television

What type of charger does a Quickcell Bolt Mini Universal Bluetooth Headset use?

Common with a lot of these bluetooth headsets, with internal rechargeable batteries, they just need the 5 volts provided by any USB socket.The charging current is controlled internally by the device.Just find a USB lead that fits the small socket on the headset and has a standard USB plug on the other end.Then Plug the standard USB plug into any USB Powered device. Computer, car charger adapter, Wall charger adapter.A red light on the headset should show charging in progress.


What is the voltage used in Uganda?

It is 240V / 50Hz AC. The plug/socket used is like the one used in Great Britain.


What plug socket and voltage does South Africa have?

South Africa uses 220-240V/50H 3-prong plugs that look like this: http://www.jjeac.com/UploadFiles/JJA-14%20South%20Africa%20plug.jpg


What type of computer would utilise PCMCIA standard?

PCMCIA generally refers to the expansion cards that you plug into laptop or notebook computers, such as wireless networking cards.


What are the different parts of an electric plug?

Body,pins,bolt,coatingAnswerIt depends on the electric plug. British plugs, for example, comprise two rectangular-section metal pins which connect to the line and neutral conductors; a longer third rectangular-section pin which (a) opens and the socket's safety shutters and (b) connects to the earth conductor; and a fuse which protects the circuit being supplied by the plug. These metal pins and fuse are mounted in a hard plastic casing.

Related questions

How do you change spark plugs on 2003 Toyota Camry?

Remove the coil pack for the spark plug. With a deep socket or spark plug socket, remove the plug. Taking care to not cross thread or bend the plug tip, screw in the new plug to approximately 13 pounds of torque. Replace the coil pack. Repeat for each plug.


What size spark-plug socket is needed to take the spark-plugs out of a 2004 Chevy vortex motor?

a standard 5/8 deep socket spark plug wrench


Are spark plug sockets standard on all vehicles?

no 91 crx takes a 5/8 spark plug socket


What is the socket size for a 92 Geo Metro oil drain plug?

There is a good chance that it takes a standard size socket rather than a metric socket, it was like this on my Toyota Celica. 17mm


What does a three phase motor look like?

A three phase motor looks like any other motor from the outside. It might be a little larger than a standard motor but it looks the same. If it is not hardwired but has a plug, the plug will have four prongs instead of three. The socket will look different from a standard socket or the socket for a stove or air conditioner. It will also have four holes. The hole for the ground plug will have a special indent. That makes it so you can not put the plug in wrong. A two phase motor will run the correct way regardless of how you put the plug in the socket. If you would put the plug for three phase motor in the socket the wrong way, the motor would run backwards.


Where is the spark plug located on yfz 450?

Spark plug is under gas tank. you must remove gas tank then pull coil pack off top of plug. plug is way down in head. you need plug socket and extension to get it.


What is a sentence with the word standard?

The standard plug socket did not fit the European variants.I wonder what the standard response is.Is this the standard version of the book?The hotel was not up to standard.


Do you need a plug converter with 2 or 3 prongs from your North American plug into a Australian socket?

What you need to worry about more than if the plug fits is that the voltage is correct. If you are in the US and about to plug something into a standard(US) socket make sure it either accepts 110V current or that is equipped to transform 110 into whatever it needs.


What size socket fits a DPR7EA-9 NGK spark plug?

18mm My 2005 Kymco 250cc Grandvista / Grand Dink takes this plug and I use a standard 3/8" drive 18mm Deep socket when changing the plug because none of my other sparkplug deep sockets fit.


What is the common way of referring to a plug and its corresponding socket as per the electrical engineering terminology?

Plug and socket, plug and socket outlet, plug and receptacle or plain plug and outlet all seem to be in common usage in the US. Plug and socket is possibly the only wording commonly used in the UK. [Plug and socket outlet sounds ok to a me, as a Brit, but we never really use that expression in the UK. Plug and outlet or plug and receptacle actually sound very strange!]


What size spark plug socket for 650 v-star?

18 mm spark plug socket


What size spark plug socket do you need to take off plug on Honda 400EX?

You need an 18 mm spark plug socket.