Through apple, no.
Depending on your device, there is an unofficial way.
If you have saved .shsh blobs of iOS 6 for your device and they were saved after the time the APTickets were not stored properly, or properly through iFaith or other shsh software, you may be able to downgrade.
That being said, there is no other way to do this.
No you can't, you have to pay 100,000 to switch back. My friend bought me evil with all my money without asking, and i want to switch back. The only way is to save up. Sorry
Normally there is no way you can stop this but the best way is to just switch it off completely and at the mains and leave it a couple of minutes and then switch it back on. Hope this is helpful!
( Disconnect the battery first) Feel behind the dash for the back of the switch, on the apposite that the wiring is you will feel a small spring-loaded button. Pull the switch out to the headlight position, push the button in at the back and the knob will be released, pull the knob out the rest of the way and undo nut at the front the switch is now yours. old sparky from way back hope this helps
Turn headlight switch to the left to turn off daytime runnig lights. Turn switch back to left to turn back on.
Take the door panel off. The old switch or switch cluster should pop out of the panel when you release it from the tabs. The new switch which you ordered will plug into the window switch wiring harness. This will only plug one way; therefore, you can't go wrong. Pop the switch or switch cluster back into the door panel; attach the door panel back to the door frame.
We are stationed in Germany and my wife is having family problems back in Florida. We are just interested in getting to a base back in the states and heard there is a way we can "switch" with someone. How do we go about doing this?
Remove steering wheel disconnect Quick Connects unscrew switch and pull out put back in same way
To replace the headlight switch in a 66 mustang, you first have to remove the instrument cluster housing. After you have that out of the way, you will see a small button on the housing of the switch mechanism itself. Pull the switch knob all the way out, as if turning on the headlights, then push that little button and the switch stalk will pull all the way out of the switch housing. Then unscrew the switch bezel, pull the switch housing back, so that it clears the dash, unplug that big wire connector from the side of the switch, and remove the switch entirely. To install the new switch, you just do what you just did, except do it backwards.
my 1993 and 1994 dosent have anyway of doing it!
No good way to answer this. A 3-way light switch has one wire coming to it, two wires run to the second switch and one back out of the second switch to the light. At any point, any one of the terminals may be "hot". The only one always hot is the first single terminal that is the power source.
Feel your way up the brake pedal. You will feel the switch where it rests against the pedal lever. Feel your way back along the switch and you will feel the bracket which hold it in position. Hold the switch at the back of the bracket (the other side from the brake pedal) and unscrew it in an anticlockwise direction. Pull the switch out from the bracket and then unclip the electrics. Dead simple. Refitting is the reverse. You can do this all by feel, so you don't need to be a contortionist!
All you can do is open the back way to the cell in the dungeon, by throwing the switch. You can get in the "back way" through Mordred's underground lab. (see related question)