answersLogoWhite

0


Best Answer

mark s is for start mark r is resitor

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Replacing the starter on a 1990 Chevy pickup the new starter has 2 choices for the second small wire not the positive to attach too one marked S and one marked R which is correct?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you short out a battery by replacing a starter?

yes if you dont remove the positive terminal off the battery before unistalling the starter or installing it the lead going to the starter will be hot.


How to Replacing a starter?

I need instructions for replacing a starter on a 1993 cadillac fleetwood broham.


Is replacing starter solenoid expensive?

Yes, replacing a starter solenoid is expensive. It is about $80.00 for the actual starter plus any man hours that go into installing the starter. It will end up costing around $400.00.


Why car don't start after replacing the starter?

Assuming it started before the starter was replaced, the starter and/or starter wiring are not installed correctly.


Why does my Camaro starts when battery is connected after replacing the starter?

you've got your wires crossed on your starter,


How do you replace starter solenoid on Honda Element?

The starter solenoid on a Honda Element is integral to the starter. It cannot be replaced without replacing the starter as well.


When replacing 3.0 motor in ford windstar connected the red starter wire to the positive battery side key off and it arched bad What is wrong?

Since the large cable going to the starter is the positive, I suspect the negative cable was still hooked up when this happened.Always disconnect the negative cable before working on the starter - see if doing that helps stop the sparking.See "Related Questions" below for more


How to tell if starter needs replacing?

Remove the starter and have it bench tested at your local auto parts store.


When is the starter bad?

when your battery is good and starter doesn't turn over engine. try with booster cables directly from battery to starter to eleminate bad ground or positive wire connections.positive cable to positive connection on starter and ground cable to ground on starter and with jumper wire from positive connection on starter touch it to connector on starter from ignition switch . if your starter doesn't turn over , than you have a non working starter.


Where do you connect the positive battery lead to the starter or the alternator?

Starter solenoid.


Pictures of replacing a starter on a 2000 ford explorer?

yes


Why won't my radio work after replacing my car starter?

If the battery was disconnected while the starter was being replaced, the radio would lose its memory. Reprogramming the clock and radio stations to your favorite channels should correct the problem. Consult the owners manual for directions.