Button A = Button on the right of the centre display on the console Button B = Button on the left of the centre display on the console Ignition off. Press and hold down button "A" Ignition on. The word "SERVICE" will appear in the trip computer display Turn button "B" to the right to reset the display Turn Ignition off.
2009
By replacing the front pads . they will reset automatically when the sensor sees the pads are ok.
On my 2002 Passat there is a reset button on the underside of the Windshield washer arm. Pushing that will clear the trip computer settings, per display.
How_do_you_reset_the_service_now_display_on_2006_volkswagen_passat
The ABS indicator stands for the Automatic Brake System indicator. It can be reset by restarting the entire control display.
servis ansp vw 98
From Haynes manual: * Switch off the ignition, then press and hold down the trip reset button at the bottom of the speedo. * Switch on the ignition and release the button, and note that the display will read 'Service'. * Press down the reset button for approximately 10 seconds and the display 'Service' will be erased. According to Haynes, this will automatically reset the display to a 'distance-time' interval (i.e. 10,000 miles/15,000 km). To reset to the variable/longlife interval, you have to go to a VW dealer, as they have a special instrument for this.
That can only be done by a service tech, the car is so new that it will not reset even if you disconnect the battery**the above is incorrect.To reset the service light, turn ignition switch to ON position with engine off. Observe speedometer display and tachometer multifunction display. When standard display appears press up or down arrow on the multifunction steering wheel until the FSS service indicator with one or two wrenches appears in speedometer display and service deadline appears in tachometer display.Now, press the reset button between the speedometer and the tachometer for about 4 seconds or until the tachometer display shows "Do you want to reset service interval? Confirm by using the reset button" To confirm hold down the reset button again until a signal is heard. the service indicator will display the reset interval. Reset is complete.
according to autodata service lamp can only be reset using suitable diagnostic computer Dr.Pedro VolksWagen service technician
Move through the overhead display to where it says perform service. Hold down the Reset button for a few seconds and it will reset to "3,000 miles to service"
how do you reset the passenger side airbag on a 2000 passat?
How do you reset dashboard brake light on vw passat