0
There should be a sticker in the engine compartment that shows the specific information for your vehicle. If you don't have one then it has a normal setting of 10 degrees BTDC at 800 RPM
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What are the wires coming out of a 22re ignitor?
what does the ignitor assembly do on a 87 toyota 4runner(22re)
What engine is fit to Toyota 4runner 1988 model?
22RE or the 3.0L.
What is the firing order for a 86 Toyota 22re 4 cylinder?
1342
Is it possible to replace the timing chain on a 22re Toyota engine without removing the cylinder head also does the front differential on a 4x4 need to be removed for access to the timing cover?
you do not need to remove head or differential.i never have
What's the best and easiest way to check and set timing on 94 Toyota truck 22re engine 2.4liter without taking the head off the engine block?
A timing light on #1 cylinder and align the timing marks on crankshaft and stationary mark on engine block
Your 22re is making a funny sound in the motor?
If the noise sounds like a banging sound it could be that you have a worn timing chain. Note: 22re's have timing chains not belts. You should have the noise checked-out by an experienced Toyota mechanic.
What is the proper spark plug gap for a 1994 Toyota 4x4 4-cylinder pickup?
The correct gap for the 22RE (4 cylinder) is .031
Why don't you have compression in any cylinder in 22re Toyota pickup after changing the head?
There are many reasons, loose head bolts- improper torque sequence- improper timing of the camshaft-poor valve seal at the seat.
What type of engine does a 1994 Toyota have.It's a 4 cylinder.?
22r or 22re unless it's been changed.
What should it cost to have a timing chain kit installed on a 1993 Toyota Truck with a 22RE Engine?
Five hundred dollars.
Where is the Fuel filter location for 87 Toyota 4Runner?
The fuel filter on an 87 4runner with a 22re is bolted to the block under the intake on the passenger side. It's a little difficult to get to, but it can be done without removing the fuel injection system.
What sizes are the nuts for the Down pipe that connects to the manifold on a 1988 Toyota 4Runner?
I have an 86 4 runner and a 22re engine. The nuts and bolts on mine are 12 mm.
