What would you like to do?

What are the cylinder head torque settings on a 1989 Toyota Town-Ace 2.0 liter with a 2CT engine code?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

I was just on the Toyota Owners Club site and found this information from Martin_Longbow; Toyota Carina E 2.0Ltr D Turbo 1996 - 98 (2C-T)

Head tightening sequence (new bolts not required)
Stage 1, 44 Nm
Stage 2, Tighten 90 Degrees
Stage 3, Tighten 90 Degrees

On the older ones there is a four stage sequence and there are 18 bolts according to the diagrame I have for the tightening sequence I hope it's of some help.
Thanks for the feedback!

What are the torque wrench settings for a 1989 Vuaxhall Nova 993cc or Opel Corsa 993cc engine including the big end settings and sump settings and cylinder head settings?

  Answer     New cylinder head bolts are required and an angle guage,or you can make one up with card and a set square.   Head bolt torque is 25Nm(newton metr

What is the head bolt torque on a 1997 ford escort 2.0 liter engine?

Install the cylinder head and tighten the bolts in the illustrated sequence (see link below), using the following steps: 1. Tighten all the bolts in sequence to 30-44 ft. lb