Carpet tiles are moderatly high tech flooring, the install instructions are available from the manufacturer & that will include the allowable & recommended adhesives.
Without any specifics, I can tell you that almost all recommend a "Pressure sensitive" adhesive, rolled on with a paint roller & allowed to dry to the touch before putting the tiles in place.
Look in the yellow pages for "carpet installation supply" store & ask them for a price & spread rate. Expect to pay 30-100 per gallon for this wonder goo. It isn't cheap but it goes on thin.
If it appeals to you, you can.
If you will use it inside the house then it's ok, but if you will use it inside the bathroom it is not advisable because wall tiles are slippery when wet. Slippery floroing is not good in the bathroom. It can cause accidents. Simpley put - NO. wall tiles are frequently thinner than flooring tiles and have a surface designed to allow water to stay on the surface. Floor tiles have a degree of grip to prevent slipping. GOOD Trades people will not put these down on floors
You could but it's not advisableWall tile adhesive is thicker so it won't run down the wall and the tiles are less likely to slipANS 2 - I have done this a few times. If you use tile spacers, no problem.
Not JUST a grout no. You can get a cement that will also work as a grout but a pure grout would not have the adhesion required to stick the tiles to the wall properly, you should not use it as a cement.
That would depend on whether they are ceramic tiles or more vinyl tiles.
Yes, there are step by step instructions you can use to install carpet tiles by yourself. You will have to carefully measure against the wall to place each tiles across your floor.
If it appeals to you, you can.
You would be better off buying a rug or a large piece of carpet remnant if you don't want to take the original carpet up. The peel and stick won't stick and you would end up with a tripping hazard.
It is possible to do but not a recommended practice Carpet tiles are designed to be installed over a stable surface. Even if you use one of the solvent based outdoor adhesives there will be some movement of one carpet against the other. This abrading will result in premature separation of the layers and you will be constantly trying to re adhere sections of the floor as they come loose. The best procedure is to remove the existing carpet, prep the surface & then install the tiles.
1.333
Different manufacturers use different types of adhesives, so ask the retailer to be sure. Generally, the manufacturers use a specially formulated latex emulsion pressure-sensitive adhesive that is releasable to facilitate easy removal of the carpet tiles without leaving behind a lot of residue.
You can get stain carpet remover and it comes out perfectly and if you don't have that try soap and water if that doesn't work then if your carpet is white you can use bleach but only if your carpet is white!!
No. There would be far to much movement, and it likely would never stick.
Yes, you can use wax.
I don't see why not, it seems to have alot of uses, and they say it will stick to anything.
No, the carpet pad moves far to much and your tile will look loose and crooked in a very short amount of time. Also, the carpet pad will not allow the adhesive to bond to it.
The double sided tape will keep the carpet down, but not for long. The best thing to use is to turn to the use of specialized carpet glue.