0
Defective or mis-adjusted brake light switch
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What causes brake lights of a 1998 Toyota Corolla to remain on?
There is a rubber piece missing near your brake pedal. My friend had the same problem and his mechanic just put a small rubber piece there. Not exactly sure what it's called..
Why do Toyota dash lights stay on after engine starts?
A bad relay switch could be the culprit if dash lights remain on after engine starts in a Toyota. Cold weather can also cause these lights to stay on after the engine starts.
What causes a PT cruiser fog lights to remain on?
A failed switch is a common cause.
What causes the brake lights remain on?
Bad brake switch. Typically located at the top of the brake pedal.
What causes airbag lights to remain on?
Either you have a bad clock spring, located in the steering wheel, or you have a bad collision sensor.
What causes emission light on 2000 Lincoln LS to remain on?
the emission lights could be comming on because your catalytic converter is not working right.
Why do your reverse lights remain on with the tail lights?
Either the switch that turns the backup lights on is out of adjustment, or has failed in the on position.
Remain stopped as long as these lights on a school bus are flashing?
Red lights flashing on a school bus mean remain stopped until they are turned off.
What gives pea plants the ability to self pollinate?
The stamens and gynoecium remain closed by keels of corolla.
Why do your brake lights remain on when you have the lights on but work just fine when they are off?
This usually means a bad or wrong bulb in the tail lights
Does 1999 Toyota Corolla turn check engine light on for certain mileage for service?
I believe so, like most Toyotas the "check engine" light will flash for about 30 seconds of starting the engine after 4500 miles since last service and will remain on constantly after 5000 miles.
How to reset alarm for 94 corolla after changing battery?
To reset an alarm for a 94 Corolla after changing the battery, place the key in the ignition and turn it slightly. Let it remain in that position for several minutes before starting the car.
