0
What could cause a 1984 Corvette when you step on the gas it breaks up real bad at 4500 RPM and does not shift or go anywhere?
Wiki User
∙ 17y ago
Hey Gary==THere is a rev limiter but it should be at about 6000 RPM. I would change the fuel filter and see if that helped. GoodluckJoe -- What else does it do? Does it just stay at that rpm and not shift, or at that rpm does it just bog down? Keep us posted. =) Boost
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What could cause drivetrain vibration in a 1974 corvette?
Could be a bad "u" joint, or may your driveshaft isn't balanced.
What could cause a 2002 corvette coups tail and dash light fuse to blow?
not sure not sure
What could cause the dash cluster not to work except for the gas gauge in a 87 corvette?
led lights inside cluster
How long after fever breaks can you go out?
You should wait at least 12-24 hours to go anywhere after a fever breaks. You may still be contagious and others could catch your sickness.
What could be pulling the battery down in 1981 Corvette?
what could be pulling the battery down in a 1981 corvette
What could cause the entire wheel with breaks and pads?
I don't think it's possible to understand the question
Which is Corvette or Lamborghini?
Lambo Aventador could kill the Corvette the Corvette only goes 330kph but Lambo Aventador goes 370.
What could be the causes of a 1965 Corvette 327 engine that will not spark?
There are a few things that can cause this problem. The spark plugs could be bad, the distributor cap could be off, the spark plug cables or boots could be damaged.Ê
What could happen if a flow control valve breaks?
It could stop the flow and cause a blockage. It may also allow to much flow through.
Will a car spin out of control when going 65 and the tie rod breaks?
You would lose all steering control, so it could spin or go anywhere.
What could cause a 1984 Corvette ignition module keep going bad is this common?
This is not common. Check to make sure there is not too much voltage at the dist.
What would cause a squealing sound at start up on 2000 corvette?
A faulty belt tensioner and/or a worn belt. A run down battery could add to it.
