0
An IDE connector is used to connect a CD-ROM drive or hard drive to a motherboard, with a long and flat ribbon cable.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What fish starts with an I?
Icefish, ide, ilisha, inanga, inconnu, Indian mullet, iniom,
What is the common coaxial connector type to support security-camera service?
F-Series Coaxial Connector
Why does my car cut out when i step on the gas when trying to start.?
you need to disconnect the two wire spout connector shorting bar located between the battery and data link connector
Where on a 88 Mitsubishi starion fuel pump location?
The electric fuel pump on 1985 to 1989 is mounted on top of the fuel tank. INSPECTION There is the connector for checking the fuel pump function in the engine compartment.(Single wire connector by air filter/the other with 2 wires is for Electronic control unit ECU diagnosis connector) Fuel pump can be operated by connecting between terminal and ground with jumper wires. 1.Connect jumper wires between fuel pump Check connector and ground,and check to ensure that operating sound of fuel pump can be heard. 2.When no operating sound can be heard, check for defective connector,wiring,etc. 3.If there is nothing wrong with connector and wiring,disconnect the fuel pump connector at the pump and energize the pump. If pump still falls to operate,replace.
On a system with one hard drive and one cd-rom what is the typical placement of the cd-rom drive?
Master drive on the primary IDE channel
How many pins does a notebook IDE connector have a desktop IDE connector?
notebook IDE connector= 44-pins Desktop IDE connector= 40-pins
What does IDE connector mean?
integrated drive electronics
What type of power connector does ide ata device have?
no
How many pin in ide connector?
It has 40 Pins
If a motherboard has one blue IDE connector and one black IDE connection which do you use to install a single drive?
Preferably to the IDE0 which most of the time is the Blue connector. The blue connector is primary, black is secondary
How many Pin In IDE Interface Connector?
It has 40 Pins
The IDE hard disk drive gets its power through what type of connector?
MOLEX connectors provide power for IDE hdd & CD-ROM drives
What does an IDE do?
An IDE connector is used to connect a CD-ROM drive or hard drive to a motherboard, with a long and flat ribbon cable.
Why cable IDE have a twist?
The twist is to identify the connector which is assigned for drive A.And the other end connector is for mother board.
What should be checked in order when a new IDE hard drive is not recognized?
The SATA connector cable, or whatever connector cable you have from the drive to the motherboard.
Where do the plugs inside the desktop for the CD hard drive go?
If it's a SATA connector, in one of the SATA ports. If it's a ribbon cable (commonly called IDE cable, but that's incorrect), into the IDE connector on the Motherboard. (that's properly named)
What is eide connector?
E-IDE connectors are enhanced versions of the industry standard IDE connectors found on most computers. E-IDE provides a higher data transfer rate and better plug and play capability.
