0
What is the correct procedure for flushing and replacing antifreeze in a 2001 Civic LX?
Wiki User
∙ 13y ago
After opening hood you will see two pipes running from up and below the radiator to engine. loosen the pipe which is above in position on engine, remove it and wait for the fluid to escape from engine
Now open radiator cap, wash opening with clean cloth ,position your mouth over the opening and blow air inside all the remaining fluid will be drained if you don't like this procedure you will have to loosen the pipe at lower end of radiator too to drain it.
after completion replace the pipes at their respective positions and add new anti freeze the amount is about 2 litres.
Start the engine and check for leaks add more coolant if required, after wards add fluid to resrve bottle and replace caps . You are done....
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
No heat Honda accord 1992 ex-r?
Replace the thermostat, and see if this corrects the situation. While you are doing this service the cooling system by flushing and replacing the coolant with a 50/50 mix of antifreeze and distilled water. Do not forget to bleed all air from the system. Inspect the radiator cap and replace if necessary. If this does not correct the, no heat, then look at the heater control valve.
What is Flushing queens postal code?
It depends on the street address. Flushing is in Zip 113. Downtown Flushing is 11355. East Flushing is 11358. Northern Flushing is 11354. Southern Flushing is 11367. You can get the correct zip code at usps.com
What are the correct spellings of procedure?
Procedure is correct.
Does the antifreeze being added after flushing need to be diluted?
The antifreeze should be diluted How much is up to you. Also be sure to configure in the location where you live (hotter, colder) as this also makes a difference I'm pretty sure that antifreeze needs some water to work properly (activates chemicals in antifreeze) If you went 70% antifreeze & 30% water you should probably be fine no matter where you live. ========================================================== Ford vehicles come from the factory with a 50 / 50 mix of distilled water and the correct type of antifreeze for the vehicle . Ford states not to exceed 60% antifreeze in the mix
Why is the water in car radiator rusty?
the water in your radiator is rusty because your antifreeze/water ratio is not correct. Antifreeze serves two important functions: protecting the cooling system at temperature extremes and inhibiting rust and corrosion in the system. When your antifreeze/water ratio is not correct Rust and sediment can accumulate in the cooling system. This can eventually clog your cooling system mainly your radiator and cause your car to overheat, and more serious problems with the over heating. I would suggest flushing your system and adding the correct antifreeze/water ratio mixture. Doing this your self or having it done by proffessional.
Correct antifreeze for 2006 dodge diesel truck?
correct antifreeze for 2006 dodge ram diesel truck
What is the correct type of antifreeze for a 1999 VW Jetta?
All antifreeze is the same.
What is correct antifreeze for 1990 dodge dynasty?
Green.
What is the correct antifreeze for a Dodge Durango 2000?
Green
What is the correct percent of antifreeze for cars in your climate?
Fords come from the factory with a 50 / 50 mix of distilled water and the correct type of antifreeze for the vehicle Ford states not to exceed 60 % antifreeze ( colder climates ) and not to drop below 40 % antifreeze for the corrosion protection ( warmer climates )
What is the correct tightening procedure for the wheel bearing?
desribe the correct tighting procedure for the wheel bearing
What type of antifreeze goes into a 1998 dodge durango?
, the mopar part # for the correct antifreeze is 4267020ab. But any green antifreeze will work. Service tech. Dodge dealer
