0
IVE GONE 147 MILES PER HOUR
I have a 95 Ford Probe gt, when I removed the stock muffler, catalytic converter, replaced my air filter box with a cold air intake I increased my horse power decently. I topped my probe gt at 151. . . It was nice.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the intake manifold on a 94 Ford Probe?
if its a v6 then its right on top of the engine. but its i4 then its behind the engine.
Will a 1994 Ford Probe Alternator fit on a 1993 Ford Probe gt?
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
What refrigerant does 94 Ford Probe use?
r134a
Can a 1989 Ford Probe tranny fit 1993 Ford Probe tranny?
noAnswerno the only years that will work are 93 to 94 ford probe, 93 to 94 Mazda 626, and 93 to 94 Mazda M6 and if its a (CD4E) Transmission good luck you will need it! Answerthe tranny form a 93-95 should work i swaped my auto out to a 5 speed from a 95 and my car is a 93 works fine few extra parts left over
Will a 93 Ford Probe door fit a 95 Ford Probe?
Nope 98-94 is one model. 95 starts a new design.
Will the engine and transmission of a 1995 Ford Probe fit into a 1993 Ford Probe?
Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.
Where is the trans filter on a 94 Ford Probe?
inside the trans. not a job for amatuer
How do you replace the fuel pump on a Ford Probe 19 94?
take it out of the top of the tank and replace it or seal the tank off and go with a aftermarket inline fitler
Is a 94 Ford Probe interchangeable with a 97 Ford Probe?
Yes. body parts, interior parts and most motor componets are interchangeable. However, the 94 Probe is an OBD-I and the 97 Probe is an OBD-II so there are additional sensors on the 97 Probe to consider if swapping motors/wire harnesses, etc.
1994 Ford Probe squeals when started?
I Have 94 Probe 4 cylinder that squealed when I started it. the pully on the water pump was lose
Where is the inertia switch on a 94 Ford Probe?
in the trunk. under the carpet, in the leftside quarterpanel
Where is the crank shaft positioning sensor located on a 94 ford probe?
2.0ltr its in distributer
