35 foot pounds
Middle out
spark plug torque for a Toyota 2.4 is 95 inch/lbs
What is the torque specs on a 585 case ln tractor head gasket
headboltstork
petrol/deisel 2.4 or 3.0??
113nm mate
85 N·m (8.5 kg-m, 61lb-ft)
The cylinder head on a Toyota Paseo requires 33 pounds of torque on the head bolts. If the bolts are over tighten the block can warp leading to a blown head gasket.
Refer to the factory manual for correct sequence. Loosening sequence if different to tightening, and both should be done in steps, not all at once. Lightly oil thread and under head of bolts and torque as instructed in the manual. Use a new head gasket and clean the head and block surfaces. Take care not to scratch or damage the sealing surfaces. Use a torque wrench and the proper 10mm 12 point deep socket.
Torque settings on 1300 Toyota Tazz are torque to 59 foot-pounds, loosen one full-turn. Then, torque 37 foot-pounds and 68 foot-pounds. Torque sequence is 6, 4, 2, 8,7, 3, 1, 5.
Incorrect torque pounds, or incorrect sequence of torque,improper gasket installation, foreign matter not allow gasket to properly seal or warped intake manifold or warped block
Your question is best answered with" purchase a manual"! Reason being, looking for help with torque numbers also requires sequence. Without the proper sequence, you will destroy, at the very least, the head gasket. an inexpensive manual can be found at all patrts stores.