your input clutch assembly is probably burnt up you will have to smell the fluid or have some transmission technician check the clutch volume indexes with a drb (diagnostic tool)
AnswerActually it's probably your spped sensor that is located on the trans. Chrysler has always had a problem with them. My car just did the same thing, part is about $ 30. AnswerI friend of mine had the transmission replaced on his '94 Concorde about two yers ago. It was horribly expensive: more than two thousand dollars!Your car is probably stuck in " Limp Home Mode ", which is when the cars computer senses something bad is going to happen to the trans so it will only allow the car to run in reverse or 2nd gear.
Crans
That happens when the computer detects a problem.. You need to have the computer checked for trouble codes.
Could be hitting something. Better take it in and have it looked at.
Tie rods, water pump, all air conditioner components,....
The TCM (trans computer) has detected a problem and set a code. This causes the trans to go into safe mode and not shift. Have it checked for codes.
i believe it is mounted to the reverse arm on the transmission or inside the transmission,depends on model.But i could be wrong. Actually, it is screwed into the transmission on the front of the driver side near the end.
Coud be linkage adjustment Or something internal
There may be something wrong with the transmission or the linkage.
The transmission is shot ... or very very low on fluids.
If the fluid level is okay, then your transmission is about to retire.
Your 2000 Ford Contour cannot reverse because of a transmission failure problem.
Check the transmission fluid level.
the reverse switch in the transmission