0
What oxygen sensor is the Inversion Bank 1 sensor on a Mazda Protege LX the top sensor or the bottom one?
Wiki User
∙ 18y ago
It is the top one
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you Replace a Mazda Protege es Oxygen Sensor?
remove the old one and install the new one. They are threaded in.
Where is the 2003 Mazda Protege sensor 2?
How to know if air sensor not working on protege 2003
Where is the oxygen sensor on a 2003 Mazda Protege?
There is two oxygen sensors. One is located before the catalytic converter is located under the heat sheld. The oxygen sensor after the catalytic converter is found under the catalytic converter (under the car) before the catalytic transfer pipe.
How do you replace the Oxygen Sensor in a 1999 Mazda Protege SE?
Yes, they are only good for either 60,000 or 100,000 mile depending on which type was used.
Where is the oxygen sensor located on a 1993 Mazda Protege?
The sensor is located on th eexhaust manifold just above where the exhaust pipe joind the manifold. If its been on for a while, you'll probably need a torch to get it out.
Where can you find the coolant sensor on a 91 Mazda protege?
no sensor only a thermostat
Where is the oxygen sensor located on a 2006 Pontiac Vibe?
The oxygen sensor is locate on the exhaust manifold towards the rear of the motor, upstream on the top before the cat and downstream on the bottom after the cat.
What does Check Engine Light Code P0140 on a 1997 Mazda Protege 1.8L stand for?
It means there is bad/no connection between the car's computer and the oxygen sensor after the catalytic converter.
Where is the IAT sensor located on a 00 Mazda protege?
On air box right befor maf sensor
Where is the locations of oxygen sensor for Mitsubishi Outlander?
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
What is the signal wire for MAF for a 94 Mazda protege?
need to know what wire go were for a 94 Mazda protege MAF sensor
Do you need a oxygen sensor for headers?
If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.
