You need to check all the connections on the starter and battery REAL REAL CLOSE
Check ALL grounds. Make sure they are tight and very clean.
If all that's okay then replace starter. Turn your head lights on and see if they go out
when you get someone to try to start engine. If they do then you have a bad connection some where. If thay stay bright and wires or tight then replace starter.
IS your battery good and at a full charge it should have at least 12.4 volts at the battery.
When you attempt to start engine, nothing happens-- similar to weak or dead battery. You may hear "click" and lights may dim, but engine will not rotate
It could be, a dead battery, dirty or loose battery connections, a bad starter, the engine is seized.
If a starter relay or solenoid is bad, usually you will only hear a single click when you turn the key to start the engine.
There are numerous reasons this question needs to be a little more specific. What exactly is going on when you try to start the blazer? Is the engine trying to turn over but you only hear a bunch of ticking and then the ticking stops, if so then you need to replace your starter. If you just turn the key do the dash lights still come on, you may have a low, or dead, battery. Does it start but will not run after you put it in gear? Maybe you have a fuel problem or are in severe need of a tune up.
Bad starter is easy: when you turn the car on provided your battery is good, you will hear a click in the engine compartment, but the car will not start.
when i turn the ignition key i jus hear a click noise coming from the engine. any body have any ideas of what it could be ? and well it wont accelarate and go anywhere .. ?
go back to the basics...you need 3 things for your engine to run...fuel...spark...and timing. can you hear the 2 second burst from the fuel pump when you turn the key to the run position?
perhaps your neutral safety switch is going bad. or it was just misaligned.
sounds like you have a bad ignition switch or a bad starter solenoid
depress the brake pedal and turn the engine switch to the start posiiton and start the engine,,, Does this mean to hold the brake down until you hear the engine start.
yes and i just replaced the pump and i checked the relay but sometimes it will start then i hear a cut back then the check engine light comes on
first of all when you start engine it will first roll noiseless to start or less their is know oil in the engine for lublicant the bearing befor can hear