anywhere on the frame or body that is cleaned of paint and rust.
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
once a battery is connected even if the key is not in the ignition, there is always power at certain points in your car. Connecting a battery backwards will not start your car, but it can and will fry the wires to your starter.
You connect the cables BEFORE you plug in or turn on the charger. Positive (red) to battery positive first, then negative (black) to battery ground. Then you turn on your charger and set the timer.
If your connecting a stereo, it's always best to ground directly to the negative side of the battery: however you can connect to a ground under the dash also. Some autos have a ground block at the fuse panel that can also be used but you will need a spade connector. your cars body is the ground.connect the stereo ground to a metal part of the car,leave the battery connected to a ground,engine should also be connected to a ground
If you are connecting 120 volts, you connect the black wire to the breaker, white wire to the neutral bar, and ground wire to the ground bar. If you are connecting 240 volts connect the black & white wires to the breaker, & ground wire to the ground bar.
To your vehicle chassis.
You can connect the battery ground cable to the frame of the vehicle or to the engine.
All batteries will have clearly marked posts, look for the molded + sign next to it or on the side of the battery. The grounding post will have a negative "-" sign next to it. If connecting your battery to the car, connect the positive post first, then the ground.
You can test your heater blower motor by connecting a ground wire to the ground. Connect a power wire, from the battery to the positive post. If the blower motor turns it is working, and if it does not it is bad.
Yes connect the positive first to the positive battery post, and then connect the negative ground to the engine somewhere and not to the battery.
Center terminal is connected to the positive from the battery. Outside is connected to ground (-).
connect the power and acc wires together and put them on the positive and the ground to the negative