The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
You can test the 2002 Chrysler 300 M knock sensor with a diagnostic tester. The diagnostic tester will tell you if the knock sensor is working.
It is located on the side of the engine block. The purpose of the knock sensor is to retard engine timing When there is an engine noise. It is a rare case that one ever goes bad.
This knock sensor contains a phezioelectric material.
yes
The knock sensor is in the V or valley of the engine. Its on the drivers side. Basicly its under the throttle body. To get to it you have to pull the intake off and the fuel injection plate. It seems hard but it really isnt, just time consuming. The car will run without it, but you wont be protected from detonation or bad gas. Dan,
can you tell me where the knock sensor is located on a 3.3l mercury villager
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
where is a knock sensor located on a 96 Pontiac Bonneville
The knock sensor is located below the intake manifold
The knock sensor is located below the intake manifold
Where is the knock sensor located on impala SS
knock sensor location