On a typical 4-cylinder 626, the starter motor is located on the lower end of the engine, to the right of the transaxle (removal would require raising the vehicle and properly securing it with appropriate jack stands). On a typical v6 626, the starter motor is located beneath the throttle position sensor, knock sensor, distributor, and other electrical connectors that interfere with the proper removal. acc083
Where is starter on a 4 cylinder mazda 626?
Follow + battery cable should connect to solenoid
You must remove the airbox assembly to access the starter from above
the starter is in the front of the engine on the bottom,on the 4 cylinder.follow the cable from the battery +.
in a v6 its in between the motor and the firewall in the drivers side.
I have never heard of an Automatic Starter. Are you talking about a Remote Starter? Now if you are asking if an A/T equipped Mazda and a Manual Transmission equipped Mazda have the same starter, the answer is yes, they are identical.
Remove the starter and inspect the ring gear on the flywheel.
hy my name is dani im from Romania i hawe an 626 1980 Mazda at home:::dani.kinez@yahoo.com you un plug the batery you une scrow the wires from the starter you can doo it from abave .lift the car an under is the starter motor ther are 2 screwbolt
its in the back of the rear left tire on top
On top of the transmission on the drivers side under the intake box
will a 1997 Mazda 626 transmission or engine interchange with a 1999-2002 Mazda 626 transmission or engine
how many belts are in mazda 626