pull off the plastic cover that says miller cycle. the abv will have a yellowish vacuum "hat" on it, right below about where the 'cycle' word is. if your miller cycle cover is missing, then the abv will be on the back(driver side) of the engine, right in the middle. at the very end of the intake. you will see the yellowish vacuum dashpot on the end of it. but, that valve never goes bad. if you are getting 1540 codes, it is most likely vacuum or vent circuit/solenoids(p1525/1526)
Mazda Millenia hoods from models 1995 to 2002 will fit on a 1995 Mazda Millenia. The Mazda Millenia was first launched in 1995.
Mazda Discontinued the Millenia in 2002.
On the 2.3 liter it is between the rear intercooler air duct and the ABV,it is a large,silver screw on top of the throtte body.
2001 Mazda millenia
where is the water pump located in Mazda millenia
how to replace a 1998 Mazda millenia alternator
open hood locate the egr valve next to it is a row of 4 solenoids. the second from the right is vent, the fourth is vacuum they clip on, but you will probably break them the first time you remove them. then, you will see how they attach.
i need a diagram to show me how to remove a starter on millenia s 1999 mazda
how to change speedometer sensor on mazda millenia 2000 2.3 v6
Need to know how to fix the horn on a 1997 mazda millenia that doesn't work?
The 626 and the Millenia share the same 2.5 liter engine,the only difference being the version in the millenia makes more power.
The S denotes the 2.3 Supercharged engine one the Mazda millenia (rather than the regular 2.5)