0
A '96 jimmy does not have a body control module (bcm), it does, however, have an engine control module (ecm) located ontop of the coolant reservoir.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the crank shaft postioning sensor for a 96 gmc jimmy?
it is located on the lower left side of the timing cover
Where is the fuel pressure regulator 1996 GMC Jimmy 4.3 tbi?
The fuel pressure regulator in that 96 GMC 4.3 TBI is located in the throttle body.
Where is the fuel sensor for 96 gmc jimmy?
I don't know about the Jimmy, specifically, but the fuel sensor on most fuel injected cars are located inside the gas tank, as part of the fuel sender (pump).
What does p1406 mean on a 96 gmc jimmy?
You have a problem with the EGR system, the pintle positon circuit.
What is the socket size to take out cv shaft nut from 96 gmc jimmy?
i think 35mm
Where is the oil filter located on a 96 jimmy gmc?
It is screwed to the engine block. Crawl under the vehicle and look for it which I suspect you have not done. If you cannot find it then you are not looking hard enough.
How do you remove the hand brake cable on a 96 gmc jimmy?
Hand brake? I thought the last GMC with a hand brake was in 68, but I could be wrong.
What size gas tank does a 96 GMC Jimmy have?
When owning a car, it is important to know and remember the gas tank size. The 1996 GMC Jimmy has a gas tank that holds up to 19 gallons of gas.
Fuses blow when you press brak pedal on 96 gmc jimmy?
Probably a crossed wire or electrical short.
What would make your 96 gmc jimmy not turn over with a good starter and alternator?
a defective starter switch
Where is the fuse for the dome light on a 96 GMC Jimmy?
It is on the left side of the dashboard,you can only see it when the door is open
Help with brake lights on 96 GMC jimmy?
The brake lights on a 96 Jimmy are operated by the brake light switch, mounted on the brake pedal assembly. If the switch is bad the lights could stay on or off, or be sporadic.
