What would you like to do?

Where is the blend door on 2001 Ford Expedition?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

Blend Door Problem Your problem sounds like the common blend door problem on the Ford Expeditions, and Ford Explorer. The door is on a vertical axis and when it breaks, it can swing back and forth randomly giving heat or AC or nothing. The difference on acceleration is the force placed on the door swinging it one direction.

You can check the operation by fully opening the glove box, removing the actuator motor on top of the plenum box and examining the blend door axle. Pictures of the common fail signature are available on the heatertreater.net web site. There are several "free" fixes that mostly are worth what you pay for them. The solution on the web site is solid and proven over hundreds of vehicles and will resolve the problem once and for all.
4 people found this useful
Thanks for the feedback!

Where is the blend door loacted on a 1998 ford expedition?

The Expedition uses the same heater box as the F150 and Lincoln Navigator. The blend door acutator motor is located on the bottom of the box and the blend door turns on a vert

Where is the blend door motor on a 1999 ford expedition?

  By Jeff Frank   First you have to remove the glove box to gain access to the plenum. Next, remove the actuator from the box. The actuator is a flat white box that s

Where is the blend door on a Ford Ranger?

The blend door sits vertically in the heater box behind the glove box. If you fully open the glove box, you can see the actuator motor on top of the heater box in the upper

Where is air blend door found on 2003 ford expedition?

open glove box drop down door, look thru hole to the left and up Actually, the actuator motor on the Expedition/Navigator is located on the bottom of the heater box above th

Where to locate a blend door on a 2001 dodge 1500 sport?

It is in the center of the HVAC housing under the dash. Dash and HVAC need removed to access. It is in the center of the HVAC housing under the dash. Dash and HVAC need remov

How do you repair the blend door motor on a 1998 Ford Expedition?

  Generally the problem is with a broken blend door, not a bad actuator motor. A solution is available at www.heatertreater.net and additional information can be found by

How do you remove the blend door actuator on a 99 Ford Expedition?

Answer   Remove glove compartment box on passenger side, u should see the actuator its white box with wire harness in front gots four SCREWS(TORX) just remove and replace

Were is the location of the blend door actuator on a 00 ford expedition your ac works fine in the rear but only blows heat in the front no matter what is selected?

  The Expedition uses the same heater box as the F150 and Lincoln Navigator. The blend door acutator motor is located on the bottom of the box and the blend door turns on

How to remove door panel on a Ford Expedition?

Remove one screw behind the panel by the rear view mirror. Pop the cover off the door light. There is one screw in there. There is also a piece of trim by the door handle that

How do you repair the heater blend door on a 1997 Ford Expedition?

Typically to fix a broken blend door, a mechanic will disassemble the entire dash, and replace the plenum box. Unfortunately this is an expensive fix because it is labor and p

How do you repair the blend door actuator on 1999 ford expedition?

  if a pen or pencil fell down the defrost, this could be it... and you'll have to dismantle the whole thing to reach it... Or you can do this: remove the center cou