0
The blower motor resistor is above the passenger side close-out panel, below the glove compartment and towards the firewall. There will be a wiring harness leading from it to the blower motor and another harness leading into it. The harness leading into it will have a 4-wire connector and the harness leading to the blower motor will have a 2-wire connector.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the blower motor resistor located on a 2001 GMC Yukon?
where is blower motor resister located on 2001 GMC Yukon
Where's the heater blower resistor located in a 2001 gmc sierra?
below glove box remove heater/air conditioning cover then remove blower motor cover
Where is your blower resistor located on your 1996 GMC sierra truck?
The resistor is located on a small circuit board close to the blower, it can be seen by removing the glove compartment.
Where is the blower Resistor 1996 GMC Sierra?
right under the intake behind the radiator
Why wont your blower run in your 96 gmc already replaced the relay?
Blower motor bad. Blower resistor bad. Switch bad. Fuse blown.
Why does the blower switch work on all but high for 1997 GMC Safari?
You need to replace the blower motor resistor. I've been there done that.
How do you remove heater box 1998 gmc serria?
How do you replace the heater blower motor resistor on a 1998 gmc serria 1500 p/u
Can you assume the blower motor on a 1998 GMC Jimmy is causing you not to have forced air after replacing the blower and AC relays and blower switch?
It can also be a blown fuse, or a defective blower motor resistor pack.
'Where is blower motor resistor on 2002 envoy located'?
where is the blower motor resistor located on 2002 gmc envoy?
Why does your GMC Canyon 2006 AC only working on full blast?
The blower motor speed resistor is burned out.
Where is the heater blower resistor located in a 2003 GMC Sierra?
under the dash on the passenger side, remove the panel on the bottom of the dash, and its behind the blower motor
Why would the blower motor on a 95 GMC truck only work on high?
usually what causes that is the blower motor resistor. Get a volt meter and test it according to it's values, 90 percent of the time it's the RESISTOR.
