Where your jack is stored in the rear left panel. Look towards the front of this panel. There is a metal box that controls your locking mechanism. The factory code for your keyless entry is on the backside of this. It is hard to get to, but by using a mirror, flashlight, and maybe loosening this module you can get to it It is in large lettering . Good luck!! Your can re-program it to your own setting if you want.
The computer module for the keyless entry system on the 2006 Ford Explorer is behind the rear passenger seat. It is located under the seat belt panel.
The body computer and engine computer both control theft alarm functions. It is not an individual module.
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
The voltage regulator is NOT built in the alternator, it is part of the ECM, that is the Engine Control Module. The module (computer) monitors the charging system and signals the alternator how much voltage to send it to keep the system working properly. the voltage regulator is built in to the alternator
The ignition control module acts like the coil and sends the sparks to the correct cylinder when the computer tells it to.
VATS is programmed into the ECU. There is no individual module. It can be bypassed relatively easily or your computer can be sent off and the VATS system can be deleted out of the programming.
Unsure of which module you are referring to...the airbags themselves are termed "modules" and one is located in the steering wheel, while the other is in the dash. If equipped with side air bags, they can be located in the seats or one of the side pillars. The computer that operates this system is typically located under the dash, near the center of the car.
The ECM (Engine Control Module) is located on the driver's side firewall and removable from under the interior dash panel. The EDIS (Electronic Distributorless Ignition System) is located on the driver's side fender directly across from the brake booster.
The ignition module on a 2002 Impala is located in part of the electrical system. In some cars, the module kept the car from starting. When the key was turned there would not be a clicking noise. The module works with the passlock system of the car.
the quad driver module is part of your computer, it controls certain parts like your emission system and fuel system that sort of stuff.
Chrysler doesn't use a reset switch. The fuel system is controlled by relays via the engine computer.