in the fuel tank just drop the tank down and it is located just on top.
Answerin the fuel tank just drop the tank down and it is located just on top. AnswerIt is located in the fuel tank which is located in front of the trunk... You can see it by crawling under the car. You can see it in the rear of the tank. You must remove the tank to access it. The filler tube just pulls out. I had to remove the gas filler door, to remove the filler tube.. If you can get the car up high enough you should be able to remove the filler tube without removing the little door..You will known when the fuel pump is working on the 1989 Dodge Dynasty because the engine will get fuel from the fuel tank. If the fuel pump is not working, the motor will be unable to idle or run.
Your fuel pump will be inside the gas tank.
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
12V
There is no fuel pump inertia reset switch on any Chrysler vehicles.
The fuel pump is located in the fuel tank, meaning you'll have to drop the tank in order to replace the pump.
Dodge doesn't use an inertia switch. It controls the fuel pump via a pcm actuated relay.
Dodge doesn't use inertia switches.
Within the fuel tank. Tank needs to be removed.
Haynes Manual
Located in fuel tank - may have to remove for access
# It inside the gas tank you got to drop the tank to get to it