0
Why would 98 ford Taurus be making noise if you changed the serpentine belt idler pulley and tension pulley?
Wiki User
∙ 14y ago
replace the belt with a goodyear bet
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does the tension pully on a 1994 jeep wrangler still makes noise after it has been replaced?
It may be the serpentine belt. Sometimes when you purchase an "on the cheap side" serpentine belt, it has a tendency of making noise even when the tension pulley has been change. Try purchasing a more expensive belt. The diamond back serpentine belt may be the best solution for this problem.
What could be making a noise like a spark knock in a 2001 Jeep Laredo have replace serpentine belt and tension pulleys - that was not it?
If it is making a noise like a spark knock, maybe it is a spark knock.
Does 1996 Ford Taurus windshield fit 1994?
The Taurus / Sable design radically changed in 1996 making the windshields, and probably all window & body parts incompatible.
What is making my 99 Taurus boil over at cap Already changed water pump and flushed system?
Sounds like thermostat is not opening and needs replacing
How do you replace serpentine belt on 99' Cadillac Seville?
There should be a tensioner pulley you put a wrench on it and twist and it will relieve tension on the belt making the old one slide right off thenn put the new one on
Serpentine bet making noise on 2002 windstarhave changed steering pump water pump tenchner still noise any idea?
There is a drive gear for the serpentine belt that is worn causing the noise. It is about $300 to replace at a decent repair shop. Crankshaft positioning Synchronizer...
When did they start making Taurus single action 45LC?
Check with Taurus Customer Service through their website.
How do you adjust the tension of the serpentine belt on a 1999 Dodge Durango?
You dont adjust the tension on a serpentine belt, Dodge uses a spring loaded tensioner located just below the alternator, If your belt is loose it is either worn, the wrong size belt or your tensioner has frozen and not moving. If it is a brand new belt I would suggest making sure the correct one was given to you from the auto parts store. If the belt has been on the vehicle for an extended period of time I would suggest replacing it.
How do you change the serpentine belt on your 2003 ford ranger XLT?
Usually, A serpentine belt system has a spring-loaded idler. Using the proper wrench, usually an 18mm, one can relieve the tension on the belt, making it relatively easy to change the belt. On most vehicles you will find a sticker either on the underside of the hood or somewhere in the engine compartment that shows how the belt goes on.
Is there a photo of the Ford Taurus block heater location?
why is my '99 ford taurus making a knock noise and smoking from under the radator
Are parts for a 1996 Ford Taurus interchangeable with a 1997 Ford Taurus?
The 1996-1998, and much of the 1999 model Taurus & Sables are virtual twins of each other - making the parts highly interchangeable.
How have clothes changed?
they have changed by making them more usefull.
