I'm assuming you have the brackets apart, or are installing A/C on a vehicle that did not come with it, and have aquired the bracket and A/C compressor. The operation is quite simple. The A/C bracket is held to the motor by 10mm bolts, thread size 10x1.5. i believe there are 4 of them total. after the bracket is secure, install the A/C compressor into the bracket. the pully side of the compressor houses 3 bolts 13mm heads. the rear side of the compressor houses 3 smaller 10mm bolts.
Again, assuming you are working with a vehicle that has not had A/C before, you will need a new serpentine belt. part number for Gates brand is 755K5, or a Goodyear part number 5050755. To install serpentine belt route belt in the correct way, release the tention on the belt tentioner with a 14mm long handle wrench, make sure belt is in all the proper grooves along the pully's and apply tention by removing the 14mm wrench.
to install a water pump on a Toyota tercel 1.5.
Lift and properly support front of car. Remove the nuts from lower half of the mounts (one per mount). Raise engine enough for the mounts to clear the frame brackets and support engine safely. Unbolt motor mount brackets from engine block. Remove mounts with engine bracket. Unbolt motor mounts from engine brackets on the bench. Reverse procedure for installation.
Easiest thing to do is lift the motor about 4" with a hoist, removing the entire mount bracket on both motor AND the Rack. Replace the mount without the brackets mounted, and install the entire assembly as one piece
you have too take the front motor mount loose and lift the engine to install it
A Caterpillar diesel motor serpentine belt diagram can be obtained from most Caterpillar dealerships. The serpentine belt diagram can also be found at many truck parts stores.
yes
The serpentine belt goes around all of your pullies in the front of your motor, behind the radiator.
The blower motor relay on a 1980 Cadillac Coupe Deville is situated on the passenger side. It is located in the vicinity of the firewall and is just below the windshield.
the belt weaves through the motor mount,there are three 15mm bolts one is a stud prop motor up with jack remove bolts and mount install belt as shown in manual then replace bracket and mount
On the Nissan NX Coupe the starter is located to the right of the transaxle and to the left of the air cleaner. The air filter will need to be removed as well as the battery to access the starter motor.
Right on the very front of the motor.
The word outboard is used as an adjective, a noun, or adverb. Example uses:Adjective: I bought a new outboard motor for the boat.Noun: We can install the new outboard on Friday.Adverb: There are brackets attached outboard to hold emergency oars.