You need to determine whether your problem is a "no crank" problem, or a "no start" problem. To determine if it is a "no crank" problem, you will need to make two jumper wires. The first jumper wire should be about 6"-8" long, clips on either end, about 18g wire. disconnect smaller gage wire wire on the starter solenoid and jumper it with your jumper wire. Turn the ignition key on and then using another heavy gage (about 10 gage) wire, go directly from the positive terminal of the battery to the terminal on the starter where the battery wire connects. The engine should crank over. If it does not, replace the starter. If it does crank over, then you don't have a "no crank" problem, you have a "no start" problem, in which case this may be an issue with the alarm system. I goit lucky in that my problem was the starter, and not the alarm system. I performed the trouble shooting that I described above to determine that it was a bad starter. I replaced the starter, and all is well!
Weak battery
try replacing your battery maybe turn the key?
check fuel pump
YOU HAVE ACTIVATED THE CARS ALARM,PUT YOUR KEY IN THE DRIVERS DOOR LOCK AND TURN IT TWICE TO THE RIGHT.
Does your underhood light come on when you open the hood ? If not , it sounds like a dead battery or poor cable connection to the battery
How to install a battery?
whirlpool cabrio powers up but wont turn on, just makes click noise
Make sure connections are on tight.
articat atv366 wont start makes a cliking noise has good battery
Dead or weak battery? Bad starter solenoid? Loose or corroded battery cable? Bad starter? bad neutral safety switch?
Check you battery
Could be the relay or bad battery cable connection at the battery or relay.