0
whirlpool cabrio powers up but wont turn on, just makes click noise
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Other than the pulley what else does a Whirlpool dryer belt have to go over when replacing?
A place to start when dealing with dryer belts and understanding how they work is that they have to go around the drum of the dryer and around the pulley of the motor. The only additional thing the belt comes into contact with is a spring-loaded tensioner. The belt does not actually go around the tensioner, but rather is pushed "in" by it.
Maytag Dryer Repair: Three Tips on Repairing Your Washing Machine?
You are bound to experience some problems with your Maytag at some point in the future. Fortunately, there are a few steps that can help you with Maytag dryer repair. Let's take a look at them. Cord Check the cord for any shortages. Switch The switch may need to be replaced if the machine fails to work. You can replace the switch with ease with the correct tools. Fuses The fuses should also be checked if you are not able to get your dryer to work properly. Maytag dryer repair is not as difficult as you may believe. The three tips listed above can help you get off to a great start.
Why won't the Whirlpool Duet Electric Dryer heat up after the 220 fuse box blew out what could be the problem and how do I correct it?
Your heating element is going out and that is why the fuse blew as well. You will need to have the heating element replaced in order for the dryer to work like it did when you bought it.
How does a kill switch work?
The KILL switch is in series with the ignition switch. When the KILL switch is open, the bike will not start.
Does the Whirlpool LTG5243D available to run off gas?
The Whirlpool LTG5243D requires a gas connection to work.
How does a trip switch work?
A trip switch is something that u have to flick so the electricity in the curcuit can start flowing
How do you recharge the ac on a 1999 Buick Century?
Buy a recharge kit and a # 134 refrigerant; follow directions. If the system is low, the compressor will not start so you will need to remove the connector on the pressure switch which is located on the dryer. The dryer is the silver cylinder on the passenger side. There are two metal prongs that you can jump across with a wire or pliers while your recharge kit is hooked up and soon the system will take a charge ;then you can plug in the low pressure switch and the system will work again.
Headlight issue 1996 metro Headlight switch off day time running lights work. Parking light switch on headlights and parking lights work headlight switch on no lights work. Anyone have ideas?
I would start with replacing the head light switch
When you turn the headlights to full the lights cut out. Where do you start?
you probably would first start out with replacing the headlight bulbs then work to the dimmer switch and electrical system from there you probably would first start out with replacing the headlight bulbs then work to the dimmer switch and electrical system from there
How does hand dryer work?
How do Hand Dryers Work
Why 1996 ford explorer power window does not work?
Check the switch first by bypassing if the others work. Start there.
What are the symptoms of a bad neutral safety switch?
The Neutral Safety switch enables the vehicle to ONLY start in either Park or neutral for Automatics and Only when clutch is engaged in vehicles with a manual Transmission. The switch will either work or not work. Their is no slow fade in operation. If the neutral safety switch is bad it will not send a signal or ground out the transmission so the vehicle will start. ALSO...If the wire leading to or from the switch is frayed , cut, or disconnected, the vehicle when not be able to start as well.
