0
Your car radio works but when you turn it up it cuts back off?
Wiki User
∙ 14y ago
you either have a blown fuse or one that is getting crossed i would recromend taking the radio out look at the wires making sure they are all in place
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Audio cuts out when you turn up radio?
you are exeeding the factory amp and speaker ratings... its so you dont fry the sterio or blow the speakers
How do you stop Picasso radio beeping?
just got radio from scrap yard plugged it in it works fine but it wont stop beeping when you turn the radio up the beeping gets louder how do you stop it.
How do you change the time on a Nissan Pulsar radio?
You need to turn off the radio and then turn it back on while holding down the clock button from there use the up and down buttons to change hour then press clock again and use the up and down buttons to change the minutes then turn off the radio. When you turn the radio on again the clock should be working
How do you get the aftermarket radio to cut off with the car?
Wire it to a power source that also cuts off when you turn the cars ignition off, like the signal lamps or something else.
My Mercedes C280 went for service. After the service when I enter the unlock code of radio I see message waiting on the consol of the radio. I think I enter a wrong code. How to reset the radio?
An answer to your question according to the book you are to turn the radio on and leave it on and you will see the message(waiting) it will stay like that for 15 minutes then the sreen will turn to code which at this point you may enter the code and it will work again. Good luck. In case you lost your code and unless you know the radio serial number (you can remove the radio and see the no behind the set) the fastest way to get your code back is to go to www.radio-code.co.uk. Follow the instruction and for 8.99 british pound (yes you have to pay for the service) you will get the right code instantly. It works for my BECKER car radio. Believe me it works.
Ford explorer radio cuts off while driving?
The radio could have a short in a wire that is being bounced and causing it to turn off. It also could be the radio is going out and should be replaced.
How valve radio works?
radio works 25 watts but if it is valve radio then it works like this listen... turn the volume high enough and quickly do the tone then just tap the off button and turn it on then everything will be installed in it and press play or some others thats the hacked way guys thanks.
Can cuts turn into blisters?
there is no way cuts can turn to blisters
How can you fit an Xcar link on vw Passat 2002?
Remove car radio with keys that you got with your xcarlink. Connect blue connector to back of car radio. Turn on radio and change to CD. Test if it works. Radio should show CD6 Track60 if no USB or SD cart inserted.
How do you unlock a 1996 Audi radio i don't have the code?
you turn the key on and off 25 times and the radio works as good as new.
Audio cuts out when you turn up radio?
you are exeeding the factory amp and speaker ratings... its so you dont fry the sterio or blow the speakers
My key will not turn at all cant start car 2002no radio lights every now and then door chim works?
try tuning your wheel back and forth they get stuck in lock position
How do you make the antenna on a 1993 Mercedes Benz 300se work?
Works when you turn off engine or radio.
When I turn on my car it starts but nothing works including the speedometer gas gauge temperature gauge radio ac heater and windows Can anyone tell me what's wrong I have a 2002 Oldsmobile Alero?
When I turn the car on to Accessory the radio works but everything else just stays dead.
How do you stop Picasso radio beeping?
just got radio from scrap yard plugged it in it works fine but it wont stop beeping when you turn the radio up the beeping gets louder how do you stop it.
I just bought a 2din radio hooked it up it was simple but it wont turn on what can be the issue?
There is a few things that can be wrong with a radio that will not turn on. The best thing for you to do would be to take it back to the store.
How do you set the timing on a 1991 Chevy Lumina z34?
well first you have to turn the car on then turn off the radio hit set then you use the scan and seek button to change the time then turn the radio back on and then it is set.
